[Help with 2 connect forms]

[varad gupta]

> AFAIK the banner is informational only, and clicking Continue on the
> official client doesn't actually send anything back to the gateway.
>
> At my last job the banner was used to display an AUP / "authorized
> access only" nag, and there were no ill effects when openconnect
> ignored it.
>
> Perhaps something else is going wrong with your connection: wrong
> authgroup, bad CSD response, old cert, etc.?

How do I figure this out ?

The verbose output does not mention any of these and I do end up
getting a valid IP/resolv.conf/route table etc..

Thanks in Anticipation

Regards

Varad Gupta


On Sat, Jan 31, 2015 at 12:07 AM, Kevin Cernekee <cernekee at gmail.com> wrote:
> On Fri, Jan 30, 2015 at 9:33 AM, varad gupta <vbg at linux.com> wrote:
>> I am trying to connect to a CISCO ASA VPN over SSL using openconnect.
>>
>> The authentication is certificate based.. The authentication phase
>> passes successfully. Once Authenticated, the banner that comes, asks
>> for continue/cancel to be selected. This option is visible on the web
>> page as well and the Cisco client as well..
>>
>> In openconnect, after successful auth, the banner is echoed, but how
>> would one pass a particulat input (continue in this case). In the
>> absence of selecting continue, I get the IP/Gateway etc, but am unable
>> to be a part of the network..
>>
>> Sample output below ==>
>>
>> CSTP connected. DPD 30, Keepalive 20
>> Connect Banner:
>> | Select Continue/Accept to logon...
>> |
>>
>> Connected tun0 as X.X.X.X, using SSL
>> No work to do; sleeping for 20000 ms...
>> Send CSTP Keepalive
>> No work to do; sleeping for 10000 ms...
>>
>>
>> ==============
>> How do I "select" Continue.. Any help would be deeply appreciated..
>



-- 

--

Regards

Varad Gupta