[PATCH v4 4/4] Bluetooth: hci_bcm: Add serdev support

[Loic Poulain]

Hi Marcel,


On 17/08/2017 21:48, Marcel Holtmann wrote:
> Hi Loic,
>
>> Add basic support for Broadcom serial slave devices.
>> Probe the serial device, retrieve its maximum speed and
>> register a new hci uart device.
>>
>> Tested/compatible with bcm43438 (RPi3).
>>
>> Signed-off-by: Loic Poulain <loic.poulain at gmail.com>
>> ---
>> v2: dt-bindings as separate patch
>>      rebase on upcoming pi3 dts changes
>> v3: changes in bcm serdev drivers:
>>      name refactoring and additional comments
>>      Add generic host_set_baudrate method
>>      Use agnostic device_property_read
>> v4: changes in doc and dts:
>>      Add additional params to broadcom bt dt-bindings
>>      Set the max baudrate to 2000000 instead of 921600
>>      use chosen/stdout-path instead of console=
>>      remove useless earlyprintk
>>      same changes in bcm283x.dtsi
>>
>> drivers/bluetooth/hci_bcm.c | 85 +++++++++++++++++++++++++++++++++++++++++++--
>> 1 file changed, 83 insertions(+), 2 deletions(-)
> I decided to amend your patch with the required Kconfig addition and then just applied 1/4 and 4/4 to bluetooth-next tree.
>
> For 2/4 and 3/4, I think they should go through the DT tree since they depend on other changes. I can not apply since none of these changes are in any of my parent trees.
>
>
Thanks for the amend.

Indeed 2 and 3 depend on the following DT tree changes (Stefan):
[PATCH v2] ARM: dts: bcm283x: Move the BCM2837 DT contents from arm64 to 
arm.
[PATCH V2 0/3] ARM: bcm283x: Raspberry Pi Zero W support

Regards,
Loic