[PATCH 3/3 v3] arm64: dts: rockchip: Add Orange Pi 5 Max board
Jimmy Hon
honyuenkwun at gmail.com
Sun Nov 10 20:53:27 PST 2024
The RK3588 Single Board Computer includes
- eMMC
- microSD
- UART
- 2 PWM LEDs
- RTC
- RTL8125 network controller on PCIe 2.0x1.
- M.2 M-key connector routed to PCIe 3.0x4
- PWM controlled heat sink fan.
- 2 USB2 ports
- lower USB3 port
- upper USB3 port with OTG capability
- Mali GPU
- SPI NOR flash
- Mask Rom button
- Analog audio using es8388 codec via the headset jack and onboard mic
- HDMI0
the vcc5v0_usb30 regulator shares the same enable gpio pin as the
vcc5v0_usb20 regulator.
Signed-off-by: Jimmy Hon <honyuenkwun at gmail.com>
---
arch/arm64/boot/dts/rockchip/Makefile | 1 +
.../dts/rockchip/rk3588-orangepi-5-max.dts | 130 ++++++++++++++++++
.../boot/dts/rockchip/rk3588-orangepi-5.dtsi | 8 ++
3 files changed, 139 insertions(+)
create mode 100644 arch/arm64/boot/dts/rockchip/rk3588-orangepi-5-max.dts
diff --git a/arch/arm64/boot/dts/rockchip/Makefile b/arch/arm64/boot/dts/rockchip/Makefile
index 86cc418a2255..83ad11650f0b 100644
--- a/arch/arm64/boot/dts/rockchip/Makefile
+++ b/arch/arm64/boot/dts/rockchip/Makefile
@@ -142,6 +142,7 @@ dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-jaguar.dtb
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-nanopc-t6.dtb
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-nanopc-t6-lts.dtb
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-ok3588-c.dtb
+dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-orangepi-5-max.dtb
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-orangepi-5-plus.dtb
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-quartzpro64.dtb
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-rock-5-itx.dtb
diff --git a/arch/arm64/boot/dts/rockchip/rk3588-orangepi-5-max.dts b/arch/arm64/boot/dts/rockchip/rk3588-orangepi-5-max.dts
new file mode 100644
index 000000000000..c9f17bb31710
--- /dev/null
+++ b/arch/arm64/boot/dts/rockchip/rk3588-orangepi-5-max.dts
@@ -0,0 +1,130 @@
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/pinctrl/rockchip.h>
+#include "rk3588-orangepi-5.dtsi"
+
+/ {
+ model = "Xunlong Orange Pi 5 Max";
+ compatible = "xunlong,orangepi-5-max", "rockchip,rk3588";
+};
+
+&headphone_amp {
+ /* PHONE_CTL */
+ enable-gpios = <&gpio4 RK_PB0 GPIO_ACTIVE_HIGH>;
+};
+
+&analog_sound {
+ pinctrl-names = "default";
+ pinctrl-0 = <&hp_detect>;
+ simple-audio-card,aux-devs = <&headphone_amp>;
+ simple-audio-card,hp-det-gpios = <&gpio3 RK_PD2 GPIO_ACTIVE_HIGH>;
+
+ simple-audio-card,routing =
+ "Headphones", "LOUT1",
+ "Headphones", "ROUT1",
+ "LINPUT1", "Microphone Jack",
+ "RINPUT1", "Microphone Jack",
+ "LINPUT2", "Onboard Microphone",
+ "RINPUT2", "Onboard Microphone";
+ simple-audio-card,widgets =
+ "Microphone", "Microphone Jack",
+ "Microphone", "Onboard Microphone",
+ "Headphone", "Headphones";
+};
+
+&fan {
+ /* FAN_CTL_H */
+ pwms = <&pwm9 0 50000 0>;
+};
+
+&hym8563 {
+ interrupt-parent = <&gpio0>;
+ interrupts = <RK_PC4 IRQ_TYPE_LEVEL_LOW>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&rtc_int_l>;
+};
+
+&led_blue_pwm {
+ /* PWM_LED1 */
+ pwms = <&pwm4 0 25000 0>;
+ status = "okay";
+};
+
+&led_green_pwm {
+ /* PWM_LED2 */
+ pwms = <&pwm5 0 25000 0>;
+};
+
+/* phy2 */
+&pcie2x1l1 {
+ reset-gpios = <&gpio4 RK_PD4 GPIO_ACTIVE_HIGH>;
+ vpcie3v3-supply = <&vcc3v3_pcie_eth>;
+ status = "okay";
+};
+
+&pinctrl {
+ hym8563 {
+ rtc_int_l: hym8563-int {
+ rockchip,pins = <0 RK_PC4 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
+ sound {
+ hp_detect: hp-detect {
+ rockchip,pins = <3 RK_PD2 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
+ usb {
+ usb_host_pwren: usb-host-pwren {
+ rockchip,pins = <3 RK_PD5 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+
+ usb_otg_pwren: usb-otg-pwren {
+ rockchip,pins = <4 RK_PB3 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+};
+
+&pwm4 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pwm4m0_pins>;
+ status = "okay";
+};
+
+&pwm5 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pwm5m1_pins>;
+ status = "okay";
+};
+
+&pwm9 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pwm9m2_pins>;
+ status = "okay";
+};
+
+&sfc {
+ pinctrl-names = "default";
+ pinctrl-0 = <&fspim2_pins>;
+};
+
+/* pcie eth. not a real regulator. 33VAUX */
+&vcc3v3_pcie_eth {
+ /* Ethernet_power_en */
+ gpios = <&gpio0 RK_PD3 GPIO_ACTIVE_LOW>;
+};
+
+/*
+ * Represents the vcc5v0_usb20 and vcc5v0_usb30 in the schematic,
+ * both regulators share the same enable gpio
+ */
+&vcc5v0_usb20 {
+ /* USB_HOST_PWREN */
+ gpios = <&gpio3 RK_PD5 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&usb_host_pwren>;
+};
diff --git a/arch/arm64/boot/dts/rockchip/rk3588-orangepi-5.dtsi b/arch/arm64/boot/dts/rockchip/rk3588-orangepi-5.dtsi
index 3c6e1321f13f..6459a277f973 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588-orangepi-5.dtsi
+++ b/arch/arm64/boot/dts/rockchip/rk3588-orangepi-5.dtsi
@@ -95,6 +95,14 @@ fan: pwm-fan {
pwm-leds {
compatible = "pwm-leds";
+ led_blue_pwm: led-1 {
+ color = <LED_COLOR_ID_BLUE>;
+ function = LED_FUNCTION_STATUS;
+ linux,default-trigger = "heartbeat";
+ max-brightness = <255>;
+ status = "disabled";
+ };
+
led_green_pwm: led-2 {
color = <LED_COLOR_ID_GREEN>;
function = LED_FUNCTION_INDICATOR;
--
2.47.0
More information about the Linux-rockchip
mailing list