[PATCH v5 8/9] arm64: dts: rockchip: add isp0 node for rk3399

[Tomasz Figa]

On Wed, Oct 14, 2020 at 6:27 PM Helen Koike <helen.koike at collabora.com> wrote:
>
> Hi Tomasz,
>
> On 9/26/20 10:00 AM, Tomasz Figa wrote:
> > Hi Helen,
> >
> > On Wed, Jul 22, 2020 at 12:55:32PM -0300, Helen Koike wrote:
> >> From: Shunqian Zheng <zhengsq at rock-chips.com>
> >>
> >> RK3399 has two ISPs, but only isp0 was tested.
> >> Add isp0 node in rk3399 dtsi
> >>
> >> Verified with:
> >> make ARCH=arm64 dtbs_check DT_SCHEMA_FILES=Documentation/devicetree/bindings/media/rockchip-isp1.yaml
> >>
> >> Signed-off-by: Shunqian Zheng <zhengsq at rock-chips.com>
> >> Signed-off-by: Jacob Chen <jacob2.chen at rock-chips.com>
> >> Signed-off-by: Helen Koike <helen.koike at collabora.com>
> >>
> >> ---
> >>
> >> V4:
> >> - update clock names
> >>
> >> V3:
> >> - clean up clocks
> >>
> >> V2:
> >> - re-order power-domains property
> >>
> >> V1:
> >> This patch was originally part of this patchset:
> >>
> >>     https://patchwork.kernel.org/patch/10267431/
> >>
> >> The only difference is:
> >> - add phy properties
> >> - add ports
> >> ---
> >>  arch/arm64/boot/dts/rockchip/rk3399.dtsi | 25 ++++++++++++++++++++++++
> >>  1 file changed, 25 insertions(+)
> >>
> >> diff --git a/arch/arm64/boot/dts/rockchip/rk3399.dtsi b/arch/arm64/boot/dts/rockchip/rk3399.dtsi
> >> index dba9641947a3a..ed8ba75dbbce8 100644
> >> --- a/arch/arm64/boot/dts/rockchip/rk3399.dtsi
> >> +++ b/arch/arm64/boot/dts/rockchip/rk3399.dtsi
> >> @@ -1721,6 +1721,31 @@ vopb_mmu: iommu at ff903f00 {
> >>              status = "disabled";
> >>      };
> >>
> >> +    isp0: isp0 at ff910000 {
> >> +            compatible = "rockchip,rk3399-cif-isp";
> >> +            reg = <0x0 0xff910000 0x0 0x4000>;
> >> +            interrupts = <GIC_SPI 43 IRQ_TYPE_LEVEL_HIGH 0>;
> >> +            clocks = <&cru SCLK_ISP0>,
> >> +                     <&cru ACLK_ISP0_WRAPPER>,
> >> +                     <&cru HCLK_ISP0_WRAPPER>;
> >> +            clock-names = "isp", "aclk", "hclk";
> >> +            iommus = <&isp0_mmu>;
> >> +            phys = <&mipi_dphy_rx0>;
> >> +            phy-names = "dphy";
> >> +            power-domains = <&power RK3399_PD_ISP0>;
> >
> > Should this have status = "disabled" too? The mipi_dphy_rx0 node is
> > disabled by default too, so in the default configuration the driver
> > would always fail to probe.
>
> I'm thinking what is the overall guideline here.
> Since isp and mipi_dphy are always present in the rk3399, shouldn't they always be enabled?
> Or since they are only useful if a sensor is present, we should let the dts of the board to
> enable it?

I don't have a strong opinion. I'm fine with enabling both by default
as well, as it shouldn't hurt.

That said, I recall some alternative CIF IP block being present on
this SoC as well (and patches posted recently), which AFAIR can't be
activated at the same time as the ISP, so perhaps both of the
alternatives should be disabled by default?

Best regards,
Tomasz