[PATCH net-next v3 3/3] riscv: dts: eswin: eic7700-hifive-premier-p550: enable Ethernet controller

[Yao Zi]

On Tue, Mar 03, 2026 at 02:17:32PM +0800, lizhi2 at eswincomputing.com wrote:
> From: Zhi Li <lizhi2 at eswincomputing.com>
> 
> Enable the on-board Gigabit Ethernet controller on the
> HiFive Premier P550 development board.
> 
> Signed-off-by: Zhi Li <lizhi2 at eswincomputing.com>
> ---
>  .../dts/eswin/eic7700-hifive-premier-p550.dts | 50 +++++++++++++++++
>  arch/riscv/boot/dts/eswin/eic7700.dtsi        | 54 +++++++++++++++++++
>  2 files changed, 104 insertions(+)
> 
> diff --git a/arch/riscv/boot/dts/eswin/eic7700-hifive-premier-p550.dts b/arch/riscv/boot/dts/eswin/eic7700-hifive-premier-p550.dts
> index 131ed1fc6b2e..d558f0fdfb38 100644
> --- a/arch/riscv/boot/dts/eswin/eic7700-hifive-premier-p550.dts
> +++ b/arch/riscv/boot/dts/eswin/eic7700-hifive-premier-p550.dts

...

> @@ -20,6 +22,54 @@ chosen {
>  	};
>  };
>  
> +&gmac0 {
> +	phy-handle = <&gmac0_phy0>;
> +	phy-mode = "rgmii-id";
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&gpio106_pins>;
> +	rx-internal-delay-ps = <20>;
> +	tx-internal-delay-ps = <100>;
> +	status = "okay";
> +
> +	mdio {
> +		compatible = "snps,dwmac-mdio";

Since it's implemented in the DWMAC IP, I think the mdio bus is
SoC-specific and should be put into the SoC devicetree instead.

Regards,
Yao Zi

> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +
> +		gmac0_phy0: ethernet-phy at 0 {
> +			compatible = "ethernet-phy-id001c.c916";
> +			reg = <0>;
> +			reset-gpios = <&gpioD 10 GPIO_ACTIVE_LOW>;
> +			reset-assert-us = <10000>;
> +			reset-deassert-us = <80000>;
> +		};
> +	};
> +};