[PATCH v1 2/3] spi: cadence-quadspi: Add clock configuration for StarFive JH7110 QSPI

William Qiu william.qiu at starfivetech.com
Wed May 31 18:52:38 PDT 2023



On 2023/5/31 21:20, Mark Brown wrote:
> On Wed, May 31, 2023 at 02:19:16PM +0800, William Qiu wrote:
>> On 2023/5/30 18:33, Mark Brown wrote:
> 
>> > You could always specify a different array of clocks depending on which
>> > compatible the driver sees, just like you'd conditionally request clocks
>> > individually.
> 
>> 	If specify a different array of clocks depending on which compatible
>> the driver sees, since there will also be clock operations in the suspend
>> and resume interfaces, this can make the code look complicated.
> 
> If you store the clock count and array in the driver data that should be
> fairly simple I think.
> 
>> 	as following:
> 
>> 	/* Obtain QSPI clock. */
>> 	cqspi->num_clks = devm_clk_bulk_get_all(dev, &cqspi->clks);
>> 	if (cqspi->num_clks < 0) {
>> 		dev_err(dev, "Cannot claim QSPI clock: %u\n", cqspi->num_clks);
>> 		return -EINVAL;
>> 	}
> 
>> 	This way, the code will look simpler and clearer. How do you think
>> about it.
> 
> I'm not clear how enable and disable would then work?

enable use this API:
clk_bulk_prepare_enable(dev->num_clks, dev->clks);

then disable:
clk_bulk_disable_unprepare(dev->num_clks, dev->clks);

But I'll first try specify a different array of clocks depending on which
compatible the driver sees first.

Best regards,
William



More information about the linux-riscv mailing list