[Linux-parport] [patch 3/4] block/pcd: replace pcd_sleep() with msleep()/ssleep()

[domen at coderock.org]

Use msleep()/ssleep() instead of pcd_sleep() to guarantee
the task delays as expected. TASK_INTERRUPTIBLE is used in the original code,
however there is no check on the return values / for signals, thus I believe
TASK_UNINTERRUPTIBLE (and hence msleep()) is more appropriate. Remove definition
of pcd_sleep().

Signed-off-by: Nishanth Aravamudan <nacc at us.ibm.com>
Signed-off-by: Domen Puncer <domen at coderock.org>
---


 kj-domen/drivers/block/paride/pcd.c |   12 +++---------
 1 files changed, 3 insertions(+), 9 deletions(-)

diff -puN drivers/block/paride/pcd.c~msleep_ssleep-drivers_block_paride_pcd drivers/block/paride/pcd.c
--- kj/drivers/block/paride/pcd.c~msleep_ssleep-drivers_block_paride_pcd	2005-03-05 16:11:07.000000000 +0100
+++ kj-domen/drivers/block/paride/pcd.c	2005-03-05 16:11:07.000000000 +0100
@@ -534,12 +534,6 @@ static int pcd_tray_move(struct cdrom_de
 			 position ? "eject" : "close tray");
 }
 
-static void pcd_sleep(int cs)
-{
-	current->state = TASK_INTERRUPTIBLE;
-	schedule_timeout(cs);
-}
-
 static int pcd_reset(struct pcd_unit *cd)
 {
 	int i, k, flg;
@@ -549,11 +543,11 @@ static int pcd_reset(struct pcd_unit *cd
 	write_reg(cd, 6, 0xa0 + 0x10 * cd->drive);
 	write_reg(cd, 7, 8);
 
-	pcd_sleep(20 * HZ / 1000);	/* delay a bit */
+	msleep(20);			/* delay a bit */
 
 	k = 0;
 	while ((k++ < PCD_RESET_TMO) && (status_reg(cd) & IDE_BUSY))
-		pcd_sleep(HZ / 10);
+		msleep(100);
 
 	flg = 1;
 	for (i = 0; i < 5; i++)
@@ -592,7 +586,7 @@ static int pcd_ready_wait(struct pcd_uni
 		if (!(((p & 0xffff) == 0x0402) || ((p & 0xff) == 6)))
 			return p;
 		k++;
-		pcd_sleep(HZ);
+		ssleep(1);
 	}
 	return 0x000020;	/* timeout */
 }
_