[PATCH v5 5/5] arm64: dts: qcom: talos-evk-camera: Add DT overlay

[Wenmeng Liu]

Hi Konrad,

On 1/22/2026 9:44 PM, Konrad Dybcio wrote:
> On 1/22/26 11:48 AM, Wenmeng Liu wrote:
>> Enable IMX577 via CCI on Taloss EVK Core Kit.
>>
>> The Talos EVK board does not include a camera sensor
>> by default, this DTSO has enabled the Arducam 12.3MP
>> IMX577 Mini Camera Module on the CSI-1 interface.
>>
>> Reviewed-by: Vladimir Zapolskiy <vladimir.zapolskiy at linaro.org>
>> Signed-off-by: Wenmeng Liu <wenmeng.liu at oss.qualcomm.com>
>> ---
> 
> [...]
> 
>> +&cci_i2c1 {
>> +	#address-cells = <1>;
>> +	#size-cells = <0>;
>> +
>> +	camera at 1a {
>> +		compatible = "sony,imx577";
>> +		reg = <0x1a>;
>> +
>> +		reset-gpios = <&tlmm 29 GPIO_ACTIVE_LOW>;
> 
> Let's define the pin settings for the reset pin too, otherwise lgtm

The reset pin on the Talos EVK board is different from the default. Do 
you recommend that I define the reset pin's pinctrl in the Talos EVK 
board's DTS?

Thanks,
Wenmeng