[PATCH v5 5/5] arm64: dts: qcom: talos-evk-camera: Add DT overlay

[Konrad Dybcio]

On 1/22/26 11:48 AM, Wenmeng Liu wrote:
> Enable IMX577 via CCI on Taloss EVK Core Kit.
> 
> The Talos EVK board does not include a camera sensor
> by default, this DTSO has enabled the Arducam 12.3MP
> IMX577 Mini Camera Module on the CSI-1 interface.
> 
> Reviewed-by: Vladimir Zapolskiy <vladimir.zapolskiy at linaro.org>
> Signed-off-by: Wenmeng Liu <wenmeng.liu at oss.qualcomm.com>
> ---

[...]

> +&cci_i2c1 {
> +	#address-cells = <1>;
> +	#size-cells = <0>;
> +
> +	camera at 1a {
> +		compatible = "sony,imx577";
> +		reg = <0x1a>;
> +
> +		reset-gpios = <&tlmm 29 GPIO_ACTIVE_LOW>;

Let's define the pin settings for the reset pin too, otherwise lgtm

Konrad

> +		pinctrl-0 = <&cam2_default>;
> +		pinctrl-names = "default";
> +
> +		clocks = <&camcc CAM_CC_MCLK2_CLK>;
> +		assigned-clocks = <&camcc CAM_CC_MCLK2_CLK>;
> +		assigned-clock-rates = <24000000>;
> +
> +		avdd-supply = <&vreg_s4a>;
> +
> +		port {
> +			imx577_ep1: endpoint {
> +				link-frequencies = /bits/ 64 <600000000>;
> +				data-lanes = <1 2 3 4>;
> +				remote-endpoint = <&csiphy1_ep>;
> +			};
> +		};
> +	};
> +};
>