[PATCH] stm class: Fix Kconfig symbols

[James Clark]

On 19/01/2026 3:46 pm, Leo Yan wrote:
> On Mon, Jan 19, 2026 at 12:35:23PM +0000, James Clark wrote:
> 
> [...]
> 
>>> @@ -28,7 +28,7 @@ config STM_PROTO_BASIC
>>>    config STM_PROTO_SYS_T
>>>    	tristate "MIPI SyS-T STM framing protocol driver"
>>> -	default CONFIG_STM
>>> +	default STM
>>
>> The help below here says "If you don't know what this is, say N." which
>> makes me wonder if this should be on by default or not?
> 
> STM_PROTO_BASIC is a must have config when enabling STM.  While
> STM_PROTO_SYS_T is not mandatory, but it is useful to build it so that
> users can select the protocol dynamically at runtime.
> 

Should probably change that text to say "If you don't know what this is, 
say Y" then? Otherwise it makes the default-on look like a mistake.

>> Also everything is in an "if STM" block, so "default STM" is a bit
>> redundant. It's not that obvious what the intention was.
> 
> They are two different things.
> 
> "if STM" expresses a dependency (the module depends on STM), while
> "default STM" means the module will be selected by default if STM is
> enabled.
> 

Yeah they're the same, it was just a minor nit that "if STM, depends on 
STM" seemed redundant (and obviously more error prone). "default y" 
would also be the same and not repeat the same thing twice. Don't think 
it matters too much either way.

> Thanks,
> Leo
> 
> P.s. I also tried using the "select" and "imply" syntax to enable the
> protocol configurations.  Based on testing, I did not observe any
> difference compared to using the "default" syntax.