[PATCH] stm class: Fix Kconfig symbols

[Leo Yan]

On Mon, Jan 19, 2026 at 12:35:23PM +0000, James Clark wrote:

[...]

> > @@ -28,7 +28,7 @@ config STM_PROTO_BASIC
> >   config STM_PROTO_SYS_T
> >   	tristate "MIPI SyS-T STM framing protocol driver"
> > -	default CONFIG_STM
> > +	default STM
> 
> The help below here says "If you don't know what this is, say N." which
> makes me wonder if this should be on by default or not?

STM_PROTO_BASIC is a must have config when enabling STM.  While
STM_PROTO_SYS_T is not mandatory, but it is useful to build it so that
users can select the protocol dynamically at runtime.

> Also everything is in an "if STM" block, so "default STM" is a bit
> redundant. It's not that obvious what the intention was.

They are two different things.

"if STM" expresses a dependency (the module depends on STM), while
"default STM" means the module will be selected by default if STM is
enabled.

Thanks,
Leo

P.s. I also tried using the "select" and "imply" syntax to enable the
protocol configurations.  Based on testing, I did not observe any
difference compared to using the "default" syntax.