[PATCH 2/4] arm64: dts: ti: k3-am62l-evm: Disable MMC0 internal pulls

[Moteen Shah]

Hey Judith,

On 13/02/26 00:12, Judith Mendez wrote:
> AM62L EVM has external pullups on MMC0 CMD and D0 pins [0]. Remove
> internal pullups considering:
> - having both internal and external pullups reduces the total pull-up
>    resistance < 47K resulting in a value below the spec recommended 50K ohms
> - having both pullups results in unnecessary power consumption
>
> Fixes: 00fb4c73b67d ("arm64: dts: ti: k3-am62l: add initial reference board file")
> [0] https://www.ti.com/lit/zip/SPRCAL6
> Signed-off-by: Judith Mendez <jm at ti.com>
> ---
>   arch/arm64/boot/dts/ti/k3-am62l3-evm.dts | 4 ++--
>   1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/ti/k3-am62l3-evm.dts b/arch/arm64/boot/dts/ti/k3-am62l3-evm.dts
> index cae04cce33736..5085cd255fcd5 100644
> --- a/arch/arm64/boot/dts/ti/k3-am62l3-evm.dts
> +++ b/arch/arm64/boot/dts/ti/k3-am62l3-evm.dts
> @@ -253,9 +253,9 @@ AM62LX_IOPAD(0x01e0, PIN_INPUT_PULLUP, 0) /* (D8) I2C2_SDA */
>   
>   	mmc0_pins_default: mmc0-default-pins {
>   		pinctrl-single,pins = <
> -			AM62LX_IOPAD(0x0214, PIN_INPUT_PULLUP, 0) /* (D2) MMC0_CMD */
> +			AM62LX_IOPAD(0x0214, PIN_INPUT, 0) /* (D2) MMC0_CMD */
>   			AM62LX_IOPAD(0x020c, PIN_OUTPUT, 0) /* (B2) MMC0_CLK */
> -			AM62LX_IOPAD(0x0208, PIN_INPUT_PULLUP, 0) /* (D3) MMC0_DAT0 */
> +			AM62LX_IOPAD(0x0208, PIN_INPUT, 0) /* (D3) MMC0_DAT0 */
>   			AM62LX_IOPAD(0x0204, PIN_INPUT_PULLUP, 0) /* (D4) MMC0_DAT1 */
>   			AM62LX_IOPAD(0x0200, PIN_INPUT_PULLUP, 0) /* (C1) MMC0_DAT2 */
>   			AM62LX_IOPAD(0x01fc, PIN_INPUT_PULLUP, 0) /* (C2) MMC0_DAT3 */


Wont the change result in mismatched pullup resistance and will the 
mismatch between D0 and D1-D3 won't cause potential timing issues for 
modes with tighter timing requirements?

Regards,
Moteen