[PATCH] RISC-V: Skip stopping cycle counter

[Anup Patel]

On Mon, Feb 2, 2026 at 4:48 PM qingwei.hu <qingwei.hu at bytedance.com> wrote:
>
> From: Qingwei Hu <qingwei.hu at bytedance.com>
>
> In the riscv_pmu_sbi driver, pmu_sbi_stop_all() is intended to stop
> all available counters. However, counter 0 (the cycle counter) should
> be excluded from this operation because the counter may be used in
> user mode by rdcycle.
>
> Signed-off-by: Qingwei Hu <qingwei.hu at bytedance.com>
> ---
>  drivers/perf/riscv_pmu_sbi.c | 10 +++++++---
>  1 file changed, 7 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/perf/riscv_pmu_sbi.c b/drivers/perf/riscv_pmu_sbi.c
> index 7dd282da67ce..2bc0050dabd2 100644
> --- a/drivers/perf/riscv_pmu_sbi.c
> +++ b/drivers/perf/riscv_pmu_sbi.c
> @@ -900,11 +900,15 @@ static int pmu_sbi_get_ctrinfo(int nctr, unsigned long *mask)
>  static inline void pmu_sbi_stop_all(struct riscv_pmu *pmu)
>  {
>         /*
> -        * No need to check the error because we are disabling all the counters
> -        * which may include counters that are not enabled yet.
> +        * No need to check the error because we are disabling all available
> +        * counters (except the cycle counter) which may include counters
> +        * that are not enabled yet.
> +        *
> +        * Cycle counter is excluded because it might be accessed by user
> +        * mode via rdcycle.
>          */
>         sbi_ecall(SBI_EXT_PMU, SBI_EXT_PMU_COUNTER_STOP,
> -                 0, pmu->cmask, SBI_PMU_STOP_FLAG_RESET, 0, 0, 0);
> +                 0, pmu->cmask & ~BIT(0), SBI_PMU_STOP_FLAG_RESET, 0, 0, 0);

NAK to this patch.

Disabling all counters (including cycle and instret counters) is intentional.
Please refer to past discussions.

Regards,
Anup

>  }
>
>  static inline void pmu_sbi_stop_hw_ctrs(struct riscv_pmu *pmu)
> --
> 2.39.5
>