[PATCH v1 3/8] PCI: brcmstb: Use bridge reset if available

[Stanimir Varbanov]

On 6/28/24 23:54, Jim Quinlan wrote:
> The 7712 SOC has a bridge reset which can be described in the device tree.
> If it is present, use it. Otherwise, continue to use the legacy method to
> reset the bridge.
> 
> Signed-off-by: Jim Quinlan <james.quinlan at broadcom.com>
> ---
>  drivers/pci/controller/pcie-brcmstb.c | 24 +++++++++++++++++++-----
>  1 file changed, 19 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
> index c2eb29b886f7..4104c3668fdb 100644
> --- a/drivers/pci/controller/pcie-brcmstb.c
> +++ b/drivers/pci/controller/pcie-brcmstb.c
> @@ -265,6 +265,7 @@ struct brcm_pcie {
>  	enum pcie_type		type;
>  	struct reset_control	*rescal;
>  	struct reset_control	*perst_reset;
> +	struct reset_control	*bridge;
>  	int			num_memc;
>  	u64			memc_size[PCIE_BRCM_MAX_MEMC];
>  	u32			hw_rev;
> @@ -732,12 +733,19 @@ static void __iomem *brcm7425_pcie_map_bus(struct pci_bus *bus,
>  
>  static void brcm_pcie_bridge_sw_init_set_generic(struct brcm_pcie *pcie, u32 val)
>  {
> -	u32 tmp, mask =  RGR1_SW_INIT_1_INIT_GENERIC_MASK;
> -	u32 shift = RGR1_SW_INIT_1_INIT_GENERIC_SHIFT;
> +	if (pcie->bridge) {
> +		if (val)
> +			reset_control_assert(pcie->bridge);
> +		else
> +			reset_control_deassert(pcie->bridge);

Please check reset_control_assert/deassert() calls for error. This might
need to change the definition of brcm_pcie_bridge_sw_init_set_generic()
to return error.

~Stan