[PATCH v1 1/2] arm64: dts: ti: k3-am62: Add MCU MCAN nodes

[Francesco Dolcini]

From: Judith Mendez <jm at ti.com>

On AM62x there are no hardware interrupts routed to A53 GIC
interrupt controller for MCU MCAN IPs, so MCU MCAN nodes were
omitted from MCU dtsi.

Timer polling was introduced in commits [1][2] so now add MCU MCAN nodes
to the MCU dtsi for the Cortex A53.

[1] b382380c0d2d ("can: m_can: Add hrtimer to generate software interrupt")
[2] bb410c03b999 ("dt-bindings: net: can: Remove interrupt properties for MCAN")

Signed-off-by: Judith Mendez <jm at ti.com>
[fd: fixed labels to match datasheet numbering, revised commit message,
     fixed reg/reg-names order]
Signed-off-by: Francesco Dolcini <francesco.dolcini at toradex.com>
---
 arch/arm64/boot/dts/ti/k3-am62-mcu.dtsi | 24 ++++++++++++++++++++++++
 1 file changed, 24 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-am62-mcu.dtsi b/arch/arm64/boot/dts/ti/k3-am62-mcu.dtsi
index 19fc38157d94..fed50666d95b 100644
--- a/arch/arm64/boot/dts/ti/k3-am62-mcu.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-am62-mcu.dtsi
@@ -147,4 +147,28 @@ mcu_rti0: watchdog at 4880000 {
 		/* Tightly coupled to M4F */
 		status = "reserved";
 	};
+
+	mcu_mcan0: can at 4e00000 {
+		compatible = "bosch,m_can";
+		reg = <0x00 0x4e08000 0x00 0x200>,
+		      <0x00 0x4e00000 0x00 0x8000>;
+		reg-names = "m_can", "message_ram";
+		power-domains = <&k3_pds 188 TI_SCI_PD_EXCLUSIVE>;
+		clocks = <&k3_clks 188 6>, <&k3_clks 188 1>;
+		clock-names = "hclk", "cclk";
+		bosch,mram-cfg = <0x0 128 64 64 64 64 32 32>;
+		status = "disabled";
+	};
+
+	mcu_mcan1: can at 4e10000 {
+		compatible = "bosch,m_can";
+		reg = <0x00 0x4e18000 0x00 0x200>,
+		      <0x00 0x4e10000 0x00 0x8000>;
+		reg-names = "m_can", "message_ram";
+		power-domains = <&k3_pds 189 TI_SCI_PD_EXCLUSIVE>;
+		clocks = <&k3_clks 189 6>, <&k3_clks 189 1>;
+		clock-names = "hclk", "cclk";
+		bosch,mram-cfg = <0x0 128 64 64 64 64 32 32>;
+		status = "disabled";
+	};
 };
-- 
2.25.1