[PATCH] arm64: dts: imx8mn-var-som-symphony: fix USB OTG

[Krzysztof Kozlowski]

On 04/07/2023 17:31, Hugo Villeneuve wrote:
> On Tue, 4 Jul 2023 17:08:12 +0200
> Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org> wrote:
> 
>> On 04/07/2023 17:02, Hugo Villeneuve wrote:
>>> From: Hugo Villeneuve <hvilleneuve at dimonoff.com>
>>>
>>> USB OTG is currently broken on the Variscite Symphony EVK and imx8mn
>>> nano SOM.
>>>
>>> Import changes from linux-5.15 branch of  doen't giveto fix it.
>>>
>>> Link: https://github.com/varigit/linux-imx.git
>>> Fixes: 7358e05bddca ("arm64: dts: imx8mn-var-som-symphony: Add Variscite Symphony board with VAR-SOM-MX8MN")
>>> Signed-off-by: Hugo Villeneuve <hvilleneuve at dimonoff.com>
>>> ---
>>>  .../dts/freescale/imx8mn-var-som-symphony.dts | 37 ++++++++++++++++++-
>>>  1 file changed, 35 insertions(+), 2 deletions(-)
>>>
>>> diff --git a/arch/arm64/boot/dts/freescale/imx8mn-var-som-symphony.dts b/arch/arm64/boot/dts/freescale/imx8mn-var-som-symphony.dts
>>> index 406a711486da..aef89198f24c 100644
>>> --- a/arch/arm64/boot/dts/freescale/imx8mn-var-som-symphony.dts
>>> +++ b/arch/arm64/boot/dts/freescale/imx8mn-var-som-symphony.dts
>>> @@ -6,6 +6,7 @@
>>>  
>>>  /dts-v1/;
>>>  
>>> +#include <dt-bindings/usb/pd.h>
>>>  #include "imx8mn-var-som.dtsi"
>>>  
>>>  / {
>>> @@ -104,10 +105,29 @@ extcon_usbotg1: typec at 3d {
>>>  		compatible = "nxp,ptn5150";
>>>  		reg = <0x3d>;
>>>  		interrupt-parent = <&gpio1>;
>>> -		interrupts = <11 IRQ_TYPE_LEVEL_LOW>;
>>> +		interrupts = <11 IRQ_TYPE_NONE>;
>>
>> That's surprising, why?
> 
> Hi,
> the varigit repos log or source code has no information about this
> particular configuration.
> 
> In the schematics, the interrupt output pin of the PTN5150 is connected
> to two different resistors, one of these being connected to GPIO1 pin
> 11. But these two resistors are not assembled on any versions of the
> board, so the interrupt pin is currently not used.

OK, so there is no interrupt, but not interrupt of type none. Just drop
the property and make it optional in the bindings. The driver however
requires the interrupt, so I wonder how the device is going to work
without it?

Are you sure that interrupt line is not shorted instead of missing resistor?

Best regards,
Krzysztof