[PATCH 1/2] arm64: dts: ti: k3-j721e-main: add DP & DP PHY

[Nishanth Menon]

On 10:12-20200917, Tomi Valkeinen wrote:
> Add DT nodes for DisplayPort and DisplayPort PHY. The DP is Cadence MHDP
> 8546 and the PHY is a Cadence Torrent PHY with TI WIZ wrapper.
> 
> A slight irregularity in the bindings is the DPTX PHY register block,
> which is in the MHDP IP, but is needed and mapped by the PHY.
> 
> Signed-off-by: Tomi Valkeinen <tomi.valkeinen at ti.com>

just quick notes below:

> ---
>  arch/arm64/boot/dts/ti/k3-j721e-main.dtsi | 104 ++++++++++++++++++++++
>  1 file changed, 104 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi b/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
> index 12ceea9b3c9a..82d89dd3faf5 100644
> --- a/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
> @@ -553,6 +553,82 @@ serdes3: serdes at 5030000 {
>  		};
>  	};
>  
> +	serdes_wiz4: wiz at 5050000 {
serdes-mux ? - I think we might want to cleanup other similar usage
instead of "wiz" or maybe just "mux"?

> +		compatible = "ti,j721e-wiz-10g";
> +		#address-cells = <1>;
> +		#size-cells = <1>;
> +		power-domains = <&k3_pds 297 TI_SCI_PD_EXCLUSIVE>;
> +		clocks = <&k3_clks 297 1>, <&k3_clks 297 9>, <&dummy_cmn_refclk>;
> +		clock-names = "fck", "core_ref_clk", "ext_ref_clk";
> +		assigned-clocks = <&k3_clks 297 9>;
> +		assigned-clock-parents = <&k3_clks 297 10>;
> +		assigned-clock-rates = <19200000>;
> +		num-lanes = <4>;
> +		#reset-cells = <1>;
> +		ranges = <0x5050000 0x0 0x5050000 0x10000>,
> +			<0xa030a00 0x0 0xa030a00 0x40>;
> +
> +		wiz4_pll0_refclk: pll0-refclk {
	clock@ ?
> +			clocks = <&k3_clks 297 9>, <&dummy_cmn_refclk>;
> +			clock-output-names = "wiz4_pll0_refclk";
> +			#clock-cells = <0>;
> +			assigned-clocks = <&wiz4_pll0_refclk>;
> +			assigned-clock-parents = <&k3_clks 297 9>;
> +		};
> +
> +		wiz4_pll1_refclk: pll1-refclk {
	same?
> +			clocks = <&k3_clks 297 9>, <&dummy_cmn_refclk>;
> +			clock-output-names = "wiz4_pll1_refclk";
> +			#clock-cells = <0>;
> +			assigned-clocks = <&wiz4_pll1_refclk>;
> +			assigned-clock-parents = <&k3_clks 297 9>;
> +		};
> +
> +		wiz4_refclk_dig: refclk-dig {
	same?
> +			clocks = <&k3_clks 297 9>, <&dummy_cmn_refclk>;
> +			clock-output-names = "wiz4_refclk_dig";
> +			#clock-cells = <0>;
> +			assigned-clocks = <&wiz4_refclk_dig>;
> +			assigned-clock-parents = <&k3_clks 297 9>;
> +		};
> +
> +		wiz4_cmn_refclk_dig_div: cmn-refclk-dig-div {
	same?
> +			clocks = <&wiz4_refclk_dig>;
> +			#clock-cells = <0>;
> +		};
> +
> +		wiz4_cmn_refclk1_dig_div: cmn-refclk1-dig-div {
	same?
> +			clocks = <&wiz4_pll1_refclk>;
> +			#clock-cells = <0>;
> +		};
> +
> +		serdes4: serdes at 5050000 {
> +			/*
> +			 * Note: we also map DPTX PHY registers as the Torrent
> +			 * needs to manage those.
> +			 */
> +			compatible = "ti,j721e-serdes-10g";
> +			reg = <0x5050000 0x10000>,
> +			      <0xa030a00 0x40>; /* DPTX PHY */
> +			reg-names = "torrent_phy", "dptx_phy";
> +
> +			resets = <&serdes_wiz4 0>;
> +			reset-names = "torrent_reset";
> +			clocks = <&wiz4_pll0_refclk>;
> +			clock-names = "refclk";
> +			#address-cells = <1>;
> +			#size-cells = <0>;
> +			torrent_phy_dp: phy at 0 {
> +				reg = <0>;
> +				resets = <&serdes_wiz4 1>;
> +				cdns,phy-type = <PHY_TYPE_DP>;
> +				cdns,num-lanes = <4>;
> +				cdns,max-bit-rate = <5400>;
> +				#phy-cells = <0>;
> +			};
> +		};
> +	};
> +
Do you see any impact of the discussions we are having at [1] ?

>  	main_uart0: serial at 2800000 {
>  		compatible = "ti,j721e-uart", "ti,am654-uart";
>  		reg = <0x00 0x02800000 0x00 0x100>;
> @@ -1024,6 +1100,34 @@ ufs at 4e84000 {
>  		};
>  	};
>  
> +	mhdp: dp-bridge at a000000 {
> +		compatible = "ti,j721e-mhdp8546";
> +		/*
> +		 * Note: we do not map DPTX PHY area, as that is handled by
> +		 * the PHY driver.
> +		 */
> +		reg = <0x0 0xa000000 0x0 0x30a00>, /* DSS_EDP0_V2A_CORE_VP_REGS_APB */
> +		      <0x0 0x4f40000 0x0 0x20>;    /* DSS_EDP0_INTG_CFG_VP */
> +		reg-names = "mhdptx", "j721e-intg";
> +
> +		status = "disabled";
> +
> +		clocks = <&k3_clks 151 36>;
> +
> +		phys = <&torrent_phy_dp>;
> +		phy-names = "dpphy";
> +
> +		interrupt-parent = <&gic500>;
> +		interrupts = <GIC_SPI 614 IRQ_TYPE_LEVEL_HIGH>;
> +
> +		power-domains = <&k3_pds 151 TI_SCI_PD_EXCLUSIVE>;
> +
> +		dp0_ports: ports {
> +			#address-cells = <1>;
> +			#size-cells = <0>;
> +		};
> +	};
> +
>  	dss: dss at 04a00000 {
>  		compatible = "ti,j721e-dss";
>  		reg =
> -- 
> Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
> Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
> 

[1] https://lore.kernel.org/linux-devicetree/8a27f8f3-20c4-f72c-b683-81153107d867@ti.com/
-- 
Regards,
Nishanth Menon
Key (0xDDB5849D1736249D) / Fingerprint: F8A2 8693 54EB 8232 17A3  1A34 DDB5 849D 1736 249D