[PATCH v4 1/5] arm64: dts: ti: Makefile: Use ARCH_K3 for building dtbs

[Suman Anna]

On 9/14/20 11:22 AM, Lokesh Vutla wrote:
> To allow lesser dependency and better maintainability use CONFIG_ARCH_K3
> for building dtbs for all K3 based devices. This is as per the
> discussion in [0].
> 
> [0] https://lore.kernel.org/linux-arm-kernel/20200908112534.t5bgrjf7y3a6l2ss@akan/
> 
> Signed-off-by: Lokesh Vutla <lokeshvutla at ti.com>

Reviewed-by: Suman Anna <s-anna at ti.com>

regards
Suman

> ---
>  arch/arm64/boot/dts/ti/Makefile | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/ti/Makefile b/arch/arm64/boot/dts/ti/Makefile
> index 05c0bebf65d4..7f28be62b8da 100644
> --- a/arch/arm64/boot/dts/ti/Makefile
> +++ b/arch/arm64/boot/dts/ti/Makefile
> @@ -3,9 +3,9 @@
>  # Make file to build device tree binaries for boards based on
>  # Texas Instruments Inc processors
>  #
> -# Copyright (C) 2016-2018 Texas Instruments Incorporated - https://www.ti.com/
> +# Copyright (C) 2016-2020 Texas Instruments Incorporated - https://www.ti.com/
>  #
>  
> -dtb-$(CONFIG_ARCH_K3_AM6_SOC) += k3-am654-base-board.dtb
> +dtb-$(CONFIG_ARCH_K3) += k3-am654-base-board.dtb
>  
> -dtb-$(CONFIG_ARCH_K3_J721E_SOC) += k3-j721e-common-proc-board.dtb
> +dtb-$(CONFIG_ARCH_K3) += k3-j721e-common-proc-board.dtb
>