[PATCH V2 1/2] thermal: ti-soc-thermal: Enable addition power management

[Andreas Kemnade]

On Thu, 10 Sep 2020 14:33:13 -0500
Adam Ford <aford173 at gmail.com> wrote:

> On Thu, Sep 10, 2020 at 2:14 PM Daniel Lezcano <daniel.lezcano at linaro.org>
> wrote:
> 
> > On 10/09/2020 20:01, Andreas Kemnade wrote:  
> > > On Wed, 19 Aug 2020 07:59:23 -0500
> > > Adam Ford <aford173 at gmail.com> wrote:
> > >  
> > >> The bandgap sensor can be idled when the processor is too, but it
> > >> isn't currently being done, so the power consumption of OMAP3
> > >> boards can elevated if the bangap sensor is enabled.
> > >>
> > >> This patch attempts to use some additional power management
> > >> to idle the clock to the bandgap when not needed.
> > >>
> > >> Signed-off-by: Adam Ford <aford173 at gmail.com>
> > >> Reported-by: kernel test robot <lkp at intel.com>
> > >> ---
> > >> V2: Fix issue where variable stating the suspend mode isn't being
> > >>     properly set and cleared.
> > >>  
> > > hmm, it is not in linux-next. Can we expect that for v5.10?  
> >
> > The reason I did not pick this patch is because lkp reported an error on
> > it.
> >
> > https://marc.info/?l=linux-pm&m=159788472017308&w=2
> >
> >
> >  
> That error message shows it's trying to be built with 'sh' cross compiler,
> but should be build with an ARM.
> 
> I can run a manual test of the patch against a different branch if
> necessary, but I had built and tested it, so I know it worked at one time.
> 
hmm, what about compile-testing without CONFIG_PM_SLEEP?

The function definition is guarded by that.
So it is not a sh-specific problem.

Regards,
Andreas