[PATCH V2 1/2] thermal: ti-soc-thermal: Enable addition power management

[Daniel Lezcano]

On 10/09/2020 20:01, Andreas Kemnade wrote:
> On Wed, 19 Aug 2020 07:59:23 -0500
> Adam Ford <aford173 at gmail.com> wrote:
> 
>> The bandgap sensor can be idled when the processor is too, but it
>> isn't currently being done, so the power consumption of OMAP3
>> boards can elevated if the bangap sensor is enabled.
>>
>> This patch attempts to use some additional power management
>> to idle the clock to the bandgap when not needed.
>>
>> Signed-off-by: Adam Ford <aford173 at gmail.com>
>> Reported-by: kernel test robot <lkp at intel.com>
>> ---
>> V2: Fix issue where variable stating the suspend mode isn't being
>>     properly set and cleared.
>>
> hmm, it is not in linux-next. Can we expect that for v5.10?

The reason I did not pick this patch is because lkp reported an error on it.

https://marc.info/?l=linux-pm&m=159788472017308&w=2




-- 
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog