[PATCH v3 1/5] arm64: dts: ti: Makefile: Use ARCH_K3 for building dtbs

[Lokesh Vutla]

To allow lesser dependency and better maintainability use CONFIG_ARCH_K3
for building dtbs for all K3 based devices. This is as per the
discussion in [0].

[0] https://lore.kernel.org/linux-arm-kernel/20200908112534.t5bgrjf7y3a6l2ss@akan/

Signed-off-by: Lokesh Vutla <lokeshvutla at ti.com>
---
 arch/arm64/boot/dts/ti/Makefile | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/ti/Makefile b/arch/arm64/boot/dts/ti/Makefile
index 05c0bebf65d4..e7bfb16fa816 100644
--- a/arch/arm64/boot/dts/ti/Makefile
+++ b/arch/arm64/boot/dts/ti/Makefile
@@ -6,6 +6,6 @@
 # Copyright (C) 2016-2018 Texas Instruments Incorporated - https://www.ti.com/
 #
 
-dtb-$(CONFIG_ARCH_K3_AM6_SOC) += k3-am654-base-board.dtb
+dtb-$(CONFIG_ARCH_K3) += k3-am654-base-board.dtb
 
-dtb-$(CONFIG_ARCH_K3_J721E_SOC) += k3-j721e-common-proc-board.dtb
+dtb-$(CONFIG_ARCH_K3) += k3-j721e-common-proc-board.dtb
-- 
2.28.0