Hostapd and ath9k - AP not working
Sat Mar 28 01:28:46 PDT 2009
Did testing with station and a linksys router on 11n mode today and was able
to get iperf throughput of 80 Mb between the station and a computer through
the router. So there seems to be something wrong with the ap code, but I
can't figure out where the problem might be.
On Tue, Mar 24, 2009 at 12:19 PM, Jouni Malinen <j at w1.fi> wrote:
> On Tue, Mar 24, 2009 at 12:09:51PM -0700, Helena Zhang wrote:
> > I tried setting channel and hw_mode:
> > interface=wlan0
> > driver=nl80211
> > ssid=test
> > channel=1
> > hw_mode=g
> > ieee80211n=1
> > But then I get:
> > Mode: IEEE 802.11g Channel: 1 Frequency: 2412 MHz
> > Could not set channel for kernel driver
> Hmm.. That does not look good. Could you please send 'iw list' output?
> See http://wireless.kernel.org/en/users/Documentation/iw if you do not
> have a relatively recent version of iw. Please also send 'dmesg' output
> after having started hostapd.
> > wlan0 IEEE 802.11abgn ESSID:""
> > Mode:Master Frequency:2.412 GHz Tx-Power=27 dBm
> > Retry min limit:7 RTS thr:off Fragment thr=2352 B
> > Encryption key:off
> > Power Management:off
> > Link Quality:0 Signal level:0 Noise level:0
> > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
> > Tx excessive retries:0 Invalid misc:0 Missed beacon:0
> > ESSID is still blank and stations are still unable to see the ap.
> Not seeing SSID in iwconfig output is actually by design when using
> driver=nl80211, so that can be ignored. Not seeing the AP is of course
> not expected.
> Jouni Malinen PGP id EFC895FA
> HostAP mailing list
> HostAP at lists.shmoo.com
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Hostap