[PATCH 1/2] wifi: ath12k: read single_chip_mlo_support parameter from QMI PHY capability

Kalle Valo kvalo at kernel.org
Wed Apr 24 08:34:27 PDT 2024


Raj Kumar Bhagat <quic_rajkbhag at quicinc.com> wrote:

> New parameter 'single_chip_mlo_support' was added in QMI PHY
> capability response message. This is an optional parameter added
> in QCN9274 firmware. This parameter states if the firmware
> supports Single-Link Operation (SLO) and Multi-Link Operation (MLO)
> within the same device.
> 
> If single_chip_mlo_support = 1, then intra device SLO/MLO is supported
> in the firmware.
> If single_chip_mlo_support = 0, then intra device SLO/MLO is not
> supported in the firmware.
> 
> Hence, add support to read 'single_chip_mlo_support' parameter from
> the QMI PHY capability response message.
> 
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.1.1-00209-QCAHKSWPL_SILICONZ-1
> 
> Signed-off-by: Raj Kumar Bhagat <quic_rajkbhag at quicinc.com>
> Signed-off-by: Kalle Valo <quic_kvalo at quicinc.com>

2 patches applied to ath-next branch of ath.git, thanks.

ae6ec4a38aa4 wifi: ath12k: read single_chip_mlo_support parameter from QMI PHY capability
da3cbd88e780 wifi: ath12k: set mlo_capable_flags based on QMI PHY capability

-- 
https://patchwork.kernel.org/project/linux-wireless/patch/20240418125609.3867730-2-quic_rajkbhag@quicinc.com/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches




More information about the ath12k mailing list