[PATCH 1/2] wifi: ath12k: read single_chip_mlo_support parameter from QMI PHY capability

[Jeff Johnson]

On 4/18/2024 5:56 AM, Raj Kumar Bhagat wrote:
> New parameter 'single_chip_mlo_support' was added in QMI PHY
> capability response message. This is an optional parameter added
> in QCN9274 firmware. This parameter states if the firmware
> supports Single-Link Operation (SLO) and Multi-Link Operation (MLO)
> within the same device.
> 
> If single_chip_mlo_support = 1, then intra device SLO/MLO is supported
> in the firmware.
> If single_chip_mlo_support = 0, then intra device SLO/MLO is not
> supported in the firmware.
> 
> Hence, add support to read 'single_chip_mlo_support' parameter from
> the QMI PHY capability response message.
> 
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.1.1-00209-QCAHKSWPL_SILICONZ-1

Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3

> 
> Signed-off-by: Raj Kumar Bhagat <quic_rajkbhag at quicinc.com>
Acked-by: Jeff Johnson <quic_jjohnson at quicinc.com>