[PATCH] ath10k: Clean the HI_ACS_FLAGS_ALT_DATA_CREDIT_SIZE flag

[Fabio Estevam]

Hi Kalle,

On Wed, Sep 15, 2021 at 1:05 PM Fabio Estevam <festevam at denx.de> wrote:
>
> On an imx6dl-pico-pi board with a QCA9377 SDIO chip, the following
> errors are observed when the board works in STA mode:
>
> Simply running "ssh user at 192.168.0.1" causes:
>
> [   55.824159] ath10k_sdio mmc1:0001:1: failed to transmit packet, dropping: -12
> [   55.832169] ath10k_sdio mmc1:0001:1: failed to submit frame: -12
> [   55.838529] ath10k_sdio mmc1:0001:1: failed to push frame: -12
> [   55.905863] ath10k_sdio mmc1:0001:1: failed to transmit packet, dropping: -12
> [   55.913650] ath10k_sdio mmc1:0001:1: failed to submit frame: -12
> [   55.919887] ath10k_sdio mmc1:0001:1: failed to push frame: -12
>
> and it is not possible to connect via ssh to the other machine.
>
> One user inspected the size of frames on Wireshark and reported
> the followig:
>
> "I was able to narrow the issue down to the mtu. If I set the mtu for
> the wlan0 device to 1486 instead of 1500, the issue does not happen.
>
> The size of frames that I see on Wireshark is exactly 1500 after
> setting it to 1486."
>
> Clearing the HI_ACS_FLAGS_ALT_DATA_CREDIT_SIZE avoids the problem and
> the ssh command works successfully after that.
>
> Tested with QCA9377 SDIO with firmware WLAN.TF.1.1.1-00061-QCATFSWPZ-1.
>
> Fixes: 2f918ea98606 ("ath10k: enable alt data of TX path for sdio")
> Signed-off-by: Fabio Estevam <festevam at denx.de>

A gentle ping on this one.