No subject

[Alexey Ivanov]

OK, Michał
Thank you,

I found preinit scripts. some of them do ifconfig and some
do patching of the default mac in firmware.bin

On 14 January 2016 at 11:21, Michal Kazior <michal.kazior at tieto.com> wrote:
> On 14 January 2016 at 06:36, Alexey Ivanov <alexeyivan at gmail.com> wrote:
>> Yes, you're right, Michał
>> putting cal.bin to lib/firmware/ath10k helped
>> (before I put it to lib/firmware/ath10k/QCA988X/hw2.0/)
>>
>> but the mac address is still 00:03:7F:00:00:00
>>
>> the output now is:
>> [   11.381198] ath10k_pci 0000:00:00.0: pci irq legacy interrupts 0
>> irq_mode 0 reset_mode 0
>> [   11.725833] ath10k_pci 0000:00:00.0: qca988x hw2.0 target
>> 0x4100016c chip_id 0x043202ff sub 0000:0000
>> [   11.735226] ath10k_pci 0000:00:00.0: kconfig debug 1 debugfs 1
>> tracing 0 dfs 0 testmode 1
>> [   11.748288] ath10k_pci 0000:00:00.0: firmware ver 10.2.4.97 api 5
>> features no-p2p crc32 f91e34f2
>> [   11.797377] ath10k_pci 0000:00:00.0: Direct firmware load for
>> ath10k/QCA988X/hw2.0/board-2.bin failed with error -2
>> [   11.807985] ath10k_pci 0000:00:00.0: Falling back to user helper
>> [   11.882960] firmware ath10k!QCA988X!hw2.0!board-2.bin:
>> firmware_loading_store: map pages failed
>> [   11.893044] ath10k_pci 0000:00:00.0: board_file api 1 bmi_id N/A
>> crc32 e623b3be
>> [   12.947352] ath10k_pci 0000:00:00.0: htt-ver 2.1 wmi-op 5 htt-op 2
>> cal file max-sta 128 raw 0 hwcrypto 1
>>
>> As I understand, after correct calibration there should be normal mac?
>
> Not necessarily. I think some routers have mac addresses elsewhere. If
> you look at OpenWRT scripts you should probably find a few
> scripts/hacks that put it in board.bin (the reason for the filename is
> that at the time cal.bin support wasn't in ath10k yet).
>
>
> Michał



-- 
Best regards,
Alex Ivanov