No subject

[Michal Kazior]

On 14 January 2016 at 06:36, Alexey Ivanov <alexeyivan at gmail.com> wrote:
> Yes, you're right, Michał
> putting cal.bin to lib/firmware/ath10k helped
> (before I put it to lib/firmware/ath10k/QCA988X/hw2.0/)
>
> but the mac address is still 00:03:7F:00:00:00
>
> the output now is:
> [   11.381198] ath10k_pci 0000:00:00.0: pci irq legacy interrupts 0
> irq_mode 0 reset_mode 0
> [   11.725833] ath10k_pci 0000:00:00.0: qca988x hw2.0 target
> 0x4100016c chip_id 0x043202ff sub 0000:0000
> [   11.735226] ath10k_pci 0000:00:00.0: kconfig debug 1 debugfs 1
> tracing 0 dfs 0 testmode 1
> [   11.748288] ath10k_pci 0000:00:00.0: firmware ver 10.2.4.97 api 5
> features no-p2p crc32 f91e34f2
> [   11.797377] ath10k_pci 0000:00:00.0: Direct firmware load for
> ath10k/QCA988X/hw2.0/board-2.bin failed with error -2
> [   11.807985] ath10k_pci 0000:00:00.0: Falling back to user helper
> [   11.882960] firmware ath10k!QCA988X!hw2.0!board-2.bin:
> firmware_loading_store: map pages failed
> [   11.893044] ath10k_pci 0000:00:00.0: board_file api 1 bmi_id N/A
> crc32 e623b3be
> [   12.947352] ath10k_pci 0000:00:00.0: htt-ver 2.1 wmi-op 5 htt-op 2
> cal file max-sta 128 raw 0 hwcrypto 1
>
> As I understand, after correct calibration there should be normal mac?

Not necessarily. I think some routers have mac addresses elsewhere. If
you look at OpenWRT scripts you should probably find a few
scripts/hacks that put it in board.bin (the reason for the filename is
that at the time cal.bin support wasn't in ath10k yet).


Michał