ath10k firmware crashes in mesh mode on QCA9880

[Adrian Chadd]

Hi!

ok, thanks! I've seen some .. annoying rate control related firmware
crashes if you aren't using 11ac / 11n rates (ie you're /really/
legacy, so I wondered if something similar is going on here.

Thanks!


-a


On 13 December 2016 at 22:06, Alexis Green <agreen at cococorp.com> wrote:
> Hi Adrian,
>
> I have not done much testing of ath10k and ath9k devices in a single
> encrypted mesh recently, but I have a memory of only having this issue
> when communicating between ath10k devices.
>
> Alexis
>
> On Tue, Dec 13, 2016 at 9:53 PM, Adrian Chadd <adrian at freebsd.org> wrote:
>> Hi!
>>
>> Hm! So is there a firmware bug if there are 11n only capable nodes in
>> an 11s mesh?
>>
>>
>>
>> -adrian