[PATCH 2/5] ath10k: override CE5 config for QCA9377

[Bartosz Markowski]

Similarly to QCA6174, QCA9377 requires the CE5 configuration to be
available for other feature. Use the ath10k_pci_override_ce_config()
for it as well.

This is required for TF2.0 firmware. Previous FW revisions were
working fine without this patch.

Fixes: a70587b3389a ("ath10k: configure copy engine 5 for HTT messages")
Signed-off-by: Bartosz Markowski <bartosz.markowski at tieto.com>
---
 drivers/net/wireless/ath/ath10k/pci.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/wireless/ath/ath10k/pci.c b/drivers/net/wireless/ath/ath10k/pci.c
index 983f65bbb7fb..85367006a80a 100644
--- a/drivers/net/wireless/ath/ath10k/pci.c
+++ b/drivers/net/wireless/ath/ath10k/pci.c
@@ -3132,7 +3132,7 @@ int ath10k_pci_setup_resource(struct ath10k *ar)
 	setup_timer(&ar_pci->rx_post_retry, ath10k_pci_rx_replenish_retry,
 		    (unsigned long)ar);
 
-	if (QCA_REV_6174(ar))
+	if (QCA_REV_6174(ar) || QCA_REV_9377(ar))
 		ath10k_pci_override_ce_config(ar);
 
 	ret = ath10k_pci_alloc_pipes(ar);
-- 
2.1.2