[PATCH v2] ath10k: add QCA9377 chipset support

[Kalle Valo]

Bartosz Markowski <bartosz.markowski at tieto.com> writes:

> Add the hardware name, revision and update the pci_id table.
>
> Currently there're two HW ref. designs available I'm aware of,
> with 1.0.2 and 1.1 chip revisions. I've access and been using
> the first one so far and this patch cover only it.
>
> QCA9377 inherits most of the stuff (e.g. fw interfaces)
> from QCA61x4 design, so the integration was pretty straightforward.
>
> Signed-off-by: Bartosz Markowski <bartosz.markowski at tieto.com>

Applied, thanks.

I pushed the firmware image here:

https://github.com/kvalo/ath10k-firmware/tree/master/QCA9377/hw1.0

All reports, good or bad, are very welcome.

-- 
Kalle Valo