[PATCH V2 2/2] ath10k: Fix interrupt storm
Vasanthakumar Thiagarajan
vthiagar at qti.qualcomm.com
Tue Feb 17 02:59:16 PST 2015
On Tuesday 17 February 2015 02:53 PM, Michal Kazior wrote:
> On 17 February 2015 at 08:43, Vasanthakumar Thiagarajan
> <vthiagar at qti.qualcomm.com> wrote:
>> Promiscuous mode is enabled when wlan interface is added to
>> bridge. ath10k creates a monitor mode when promiscuous mode
>> is enabled. When monitor vdev is runing along with other
>> vdev(s) there is a huge number of interrupts generated
>> especially in noisy condition. Fix this by not enabling
>> promiscuous(monitor) mode when already a vdev is running.
>> This does not change the support of virtual interface of
>> type monitor along with other vdevs.
>>
>> Signed-off-by: Vasanthakumar Thiagarajan <vthiagar at qti.qualcomm.com>
>> ---
>> drivers/net/wireless/ath/ath10k/mac.c | 16 ++++++++++++++++
>> 1 file changed, 16 insertions(+)
>>
>> diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
>> index 3b5aaa3..66cc0a8 100644
>> --- a/drivers/net/wireless/ath/ath10k/mac.c
>> +++ b/drivers/net/wireless/ath/ath10k/mac.c
>> @@ -969,6 +969,15 @@ static int ath10k_vdev_start_restart(struct ath10k_vif *arvif, bool restart)
>> ar->num_started_vdevs++;
>> ath10k_recalc_radar_detection(ar);
>>
>> + if (ar->filter_flags & FIF_PROMISC_IN_BSS) {
>> + ar->filter_flags &= ~FIF_PROMISC_IN_BSS;
>> + ath10k_dbg(ar, ATH10K_DBG_MAC,
>> + "mac disabling promiscuous mode because vdev is started\n");
>> + ret = ath10k_monitor_recalc(ar);
>
> The entire logic should go to ath10k_monitor_recalc().
Sure.
>
> Also I'm pretty sure this breaks 4addr station briding for main 636
> fw. I can't fully test this now though (there seems to be a regression
> against fw 636 and it keeps crashing with monitor vdev over and over
> again).
Ok. Can we make this change specific to non-sta mode?.
Vasanth
>
> Michał
>
More information about the ath10k
mailing list