[PATCH] ath10k: Replace ioread with wmb for data sync

[Peter Oh]

On 02/02/2015 11:47 AM, Johannes Berg wrote:
> On Mon, 2015-02-02 at 11:36 -0800, Peter Oh wrote:
>> On 02/02/2015 11:22 AM, Johannes Berg wrote:
>>>>> You basically have the following sequence:
>>>>>
>>>>> iowrite()
>>>>> ioread()
>>>>>
>>>>> If you look, you'll see that iowrite() is actually done (or should
> be,
>>>>> or perhaps with appropriate syncs) on an uncached mapping.
>>>> since it's mmio, iowrite will be map to write, not out which is
> cached
>>>> mapping.
>>>> That's why we address "posted write" here.
>>>> If it's un-cached mapping which is volatile, we don't even need
> ioread.
>>> No, this isn't true - "posted write" in the context of this discussion
>>> is about the PCIe bus. Memory writes that go through cache aren't
>>> referred to as "posted writes", those are just (cached) memory writes.
>>>
>>>>>     As a result,
>>>>> the only thing you care about here is the PCIe bus, not the CPU
> cache
>>>>> flush. And from there on that's just a question of PCIe bus
> semantics.
>>>> So how does ioread guarantee PCIe bus transaction done?
>>> That's how PCIe works, operations are serialized, and read() has to
> wait
>>> for a response from the device
>> do you know which mechanism or which instruction set makes read() wait
>> for a response from the device?
> I have no idea. I assume it's just like a DRAM read, the CPU stalls
> while there's no response.
My explanation in this thread is all about how read() guarantees the 
wait for a response from the device, therefore why mb() - replace from 
wmb at patch set 2 - is compatible to read().
Briefly speaking,
read() -> dsb 'st' -> cpu (actually axi master in cpu) holding axi bus 
-> cpu post write buffer on axi bus -> axi bus (axi slave which is PCIe 
device) signals write completion when write transactions completed in 
write response channel ->  cpu release axi bus -> cpu program counter 
(pc) proceeds the next to read.

the exact same routines happen with mb().
mb() -> dsb 'st' -> cpu (actually axi master in cpu) holding axi bus -> 
cpu post write buffer on axi bus -> axi bus (axi slave which is PCIe 
device) signals write completion when write transactions completed in 
write response channel ->  cpu release axi bus -> cpu program counter 
(pc) proceeds the next to read.

Since axi bus master is waiting (blocking) for write completion signal 
from axi slave (PCIe device), this is how read() and mb() guarantee 
write command reaches to the device.
> johannes
>
>
> _______________________________________________
> ath10k mailing list
> ath10k at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/ath10k
Regards,
Peter