[PATCH] ath10k: Add spectral scan support for 10.4 fw

[Kalle Valo]

Raja Mani <rmani at qti.qualcomm.com> writes:

> To enable/configure spectral scan parameters in 10.4 firmware, existing
> wmi spectral related functions can be reused. Link those functions in
> 10.4 wmi ops table.
>
> In addition, adjust bin size (only when size is 68 bytes) before reporting
> bin samples to user space. The background for this adjustment is that
> qca99x0 reports bin size as 68 bytes (64 bytes + 4 bytes) in report
> mode 2. First 64 bytes carries in-band tones (-32 to +31) and last 4 byte
> carries band edge detection data (+32) mainly used in radar detection
> purpose. Additional last 4 bytes are stripped to make bin size valid one.
>
> This bin size adjustment will happen only for qca99x0, all other chipsets
> will report proper bin sizes (64/128) without extra 4 bytes being added
> at the end. The changes are validated in qca99x0 using 10.4 firmware.
>
> Signed-off-by: Raja Mani <rmani at qti.qualcomm.com>

Thanks, applied.

-- 
Kalle Valo