[PATCH] ath10k: Fill in wmi 10.4 command handlers for addba/delba debug commands

[Kalle Valo]

Vasanthakumar Thiagarajan <vthiagar at qti.qualcomm.com> writes:

> WMI 10.4 uses the same command interface as QCA988X for addba/delba
> debug wmi commands. Fill wmi_10_4_ops table with the functions used
> for QCA988X for these commands.
>
> With this change, the following debugfs entries can be used to
> configure the aggregation mode and to send addba request,
> addba response and delba respectively in manual aggregation mode
> for QCA99X0 chip.
>
> /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/aggr_mode
> /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba
> /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba_resp
> /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/delba
>
> Signed-off-by: Vasanthakumar Thiagarajan <vthiagar at qti.qualcomm.com>

Thanks, applied.

-- 
Kalle Valo