[PATCH] ath10k: Add QCA99X0 to supported device list

[Vasanthakumar Thiagarajan]

On Wednesday 05 August 2015 05:51 PM, Felix Fietkau wrote:
> On 2015-07-21 13:36, Vasanthakumar Thiagarajan wrote:
>> Add vendor/device id of QCA99X0 V2.0 to pci id table and
>> QCA99X0_HW_2_0_CHIP_ID_REV to ath10k_pci_supp_chips[] for
>> QCA99X0 to get detected by the driver.
>>
>> Signed-off-by: Vasanthakumar Thiagarajan <vthiagar at qti.qualcomm.com>
> I just tested a 99X0 card, and I'm getting this:
>
> [    8.742514] ath10k_pci 0000:01:00.0: enabling device (0140 -> 0142)
> [    8.747173] ath10k_pci 0000:01:00.0: pci irq msi interrupts 1 irq_mode 0 reset_mode 0
> [   11.793314] ath10k_pci 0000:01:00.0: failed to receive initialized event from target: 00000000
> [   11.793344] ath10k_pci 0000:01:00.0: failed to wait for target after cold reset: -110
> [   11.800814] ath10k_pci 0000:01:00.0: failed to reset chip: -110
> [   11.809228] ath10k_pci: probe of 0000:01:00.0 failed with error -110
>
> This is on an AP148 board with Linux 3.18, backports generated from
> latest wireless-testing (2015-08-03) + all patches from kvalo's ath
> tree.

Any idea about the version of AP148 that you are using?. By any chance did
you check if QCA988X is working on the same board?.

Vasanth