[PATCH v2 0/3] ath10k: speed up recovery

[Kalle Valo]

Michal Kazior <michal.kazior at tieto.com> writes:

> On 20 October 2014 14:22, Michal Kazior <michal.kazior at tieto.com> wrote:
>> Patch #1 fixes a bug I've found while testing
>> patches #2 and #3. It's safe to cherry-pick it in
>> case patches #2 and/or #3 aren't accepted or need
>> a re-spin.
>>
>> I've mainly used patch #2 to test reset and
>> recovery. It's pretty handy for (stress-)testing.
>>
>> Patch #3 should improve recovery speed in some
>> cases. Notably when there's a long chain of WMI
>> commands involved which take a painfully long time
>> to timeout/complete if firmware crashes mid-way.
>>
>> Note: Patches #2 and #3 depend on `ath10k: pci
>> related fixes 2014-10-09`. Without the patchset
>> patches #2 and #3 must not be applied. Patch #1 is
>> fine though.
>
> Do not apply this patchset yet, please. I need to do a minor fix in
> the 'ath10k: fix possible bmi crash' regarding warm reset patch from
> the other patchset.

Ok, I'm dropping these and will wait for v3.

-- 
Kalle Valo