[PATCH v2 1/6] ath10k: re-disable interrupts after target init

[Michal Kazior]

If MSI isn't configured device ROM program expects
legacy interrupts to be enabled before it can
fully boot. Don't forget to disable legacy
interrupts after that.

While at it re-use the legacy irq enabling helper
instead of calling ath10k_pci_write32().

Signed-off-by: Michal Kazior <michal.kazior at tieto.com>
---
 drivers/net/wireless/ath/ath10k/pci.c | 7 +++----
 1 file changed, 3 insertions(+), 4 deletions(-)

diff --git a/drivers/net/wireless/ath/ath10k/pci.c b/drivers/net/wireless/ath/ath10k/pci.c
index 730bb18..6077095 100644
--- a/drivers/net/wireless/ath/ath10k/pci.c
+++ b/drivers/net/wireless/ath/ath10k/pci.c
@@ -2279,14 +2279,13 @@ static int ath10k_pci_wait_for_target_init(struct ath10k *ar)
 
 		if (ar_pci->num_msi_intrs == 0)
 			/* Fix potential race by repeating CORE_BASE writes */
-			ath10k_pci_write32(ar, SOC_CORE_BASE_ADDRESS +
-					   PCIE_INTR_ENABLE_ADDRESS,
-					   PCIE_INTR_FIRMWARE_MASK |
-					   PCIE_INTR_CE_MASK_ALL);
+			ath10k_pci_enable_legacy_irq(ar);
 
 		mdelay(10);
 	} while (time_before(jiffies, timeout));
 
+	ath10k_pci_disable_and_clear_legacy_irq(ar);
+
 	if (val == 0xffffffff) {
 		ath10k_err(ar, "failed to read device register, device is gone\n");
 		return -EIO;
-- 
1.8.5.3