[PATCH 1/3] ath10k: embed supported chip ids in hw_params

[Kalle Valo]

Michal Kazior <michal.kazior at tieto.com> writes:

> This will make it easier to extend and maintain
> list of supported hardware.
>
> As a requirement this moves chip_id checking a
> little later because target_version isn't known
> until BMI can be queried.
>
> Signed-off-by: Michal Kazior <michal.kazior at tieto.com>

The reason why I originally added the chip_id check was that QCA988X hw
1.0 failed badly (ath10k might have even crashed, don't remember
anymore) and I added this chip_id as an ugly workaround to detect hw1.0
early. Most likely with this patch the problem comes back again.

I don't know what's a good solution, need to think more. Any ideas?

-- 
Kalle Valo