[PATCH 3/3] ath10k: move uart pin config into hw_params

[Michal Kazior]

This will make it possible to easily support
different hardware with different uart pin
configuration.

Signed-off-by: Michal Kazior <michal.kazior at tieto.com>
---
 drivers/net/wireless/ath/ath10k/core.c | 3 ++-
 drivers/net/wireless/ath/ath10k/core.h | 1 +
 2 files changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/net/wireless/ath/ath10k/core.c b/drivers/net/wireless/ath/ath10k/core.c
index 204aa04..0bce152 100644
--- a/drivers/net/wireless/ath/ath10k/core.c
+++ b/drivers/net/wireless/ath/ath10k/core.c
@@ -58,6 +58,7 @@ static const struct ath10k_hw_params ath10k_hw_params_list[] = {
 		.patch_load_addr = QCA988X_HW_2_0_PATCH_LOAD_ADDR,
 		.supported_chips = qca988x_supported_chips,
 		.num_supported_chips = ARRAY_SIZE(qca988x_supported_chips),
+		.uart_pin = 7,
 		.fw = {
 			.dir = QCA988X_HW_2_0_FW_DIR,
 			.fw = QCA988X_HW_2_0_FW_FILE,
@@ -708,7 +709,7 @@ static int ath10k_init_uart(struct ath10k *ar)
 	if (!uart_print)
 		return 0;
 
-	ret = ath10k_bmi_write32(ar, hi_dbg_uart_txpin, 7);
+	ret = ath10k_bmi_write32(ar, hi_dbg_uart_txpin, ar->hw_params.uart_pin);
 	if (ret) {
 		ath10k_warn(ar, "could not enable UART prints (%d)\n", ret);
 		return ret;
diff --git a/drivers/net/wireless/ath/ath10k/core.h b/drivers/net/wireless/ath/ath10k/core.h
index 1cc81e8..f8dd904 100644
--- a/drivers/net/wireless/ath/ath10k/core.h
+++ b/drivers/net/wireless/ath/ath10k/core.h
@@ -477,6 +477,7 @@ struct ath10k {
 		u32 patch_load_addr;
 		const u32 *supported_chips;
 		int num_supported_chips;
+		int uart_pin;
 		struct ath10k_hw_params_fw {
 			const char *dir;
 			const char *fw;
-- 
1.8.5.3