[RFC] Add the BMPS timer to enter/exit BMPS mode when running

[Olof Johansson]

Hello Yanbo.

No, I mean this parameter:
https://www.codeaurora.org/cgit/quic/la/platform/vendor/qcom-opensource/wlan/prima/tree/firmware_bin/WCNSS_qcom_cfg.ini?h=b2g/jb_mr1_rb2.17#n339

Cheers
--
Olof

On Wed, Jul 24, 2013 at 4:15 AM, YanBo <dreamfly281 at gmail.com> wrote:
> Hi Olof,
>
> What the specify configuration name you mentioned, do you mean
> dynamic_dtim? if so, it is used for dynamic adjust the
> DTIM value but not conflict with BMPS  timer
>
> BR /Yanbo
>
> On Wed, Jul 24, 2013 at 12:59 AM, Olof Johansson <dev at skyshaper.net> wrote:
>> On Tue, Jul 23, 2013 at 6:46 PM, Eugene Krasnikov <k.eugene.e at gmail.com> wrote:
>>> @Olof: I am not sure  what do you mean under DYNAMIC_PS but there is
>>> one configuration parameters that is responsible for how time between
>>> last data packet received from AP and NULL packet sent from STA to AP
>>> with PS bit set.
>>
>> There is a CFG parameter (sent at start or update config smd packets)
>> which is called DYNAMIC_PS which corresponds to the value of data
>> inactivity timeout in the prima .ini file. This value adjusts how long
>> the firmware is staying awake after sending or receiving a packet
>> before going back to BMPS mode. This value we adjusted several times
>> to trim throughput as well as btcoex issues.
>>
>> At least that is how it was explained to me by QC :)
>>
>> Cheers
>> --
>> Olof