[PATCH 1/2] Set correct tx width

[Eugene Krasnikov]

tx width must be set to 0 if only 20MHz is supported.
1 in case 20/40MHz supported.

Signed-off-by: Eugene Krasnikov <k.eugene.e at gmail.com>
---
 smd.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/smd.c b/smd.c
index 9fa2f0f..10de2eb 100644
--- a/smd.c
+++ b/smd.c
@@ -517,7 +517,7 @@ int wcn36xx_smd_config_sta(struct wcn36xx *wcn, const u8 *bssid,
 	sta->listen_interval = 0x8;
 	sta->wmm_enabled = 0;
 	sta->ht_capable = wcn->supported_rates.supported_mcs_set[0] ? 1 : 0;
-	sta->tx_channel_width_set = 0;
+	sta->tx_channel_width_set = conf_is_ht40(&wcn->hw->conf);
 	sta->rifs_mode = 0;
 	sta->lsig_txop_protection = 0;
 	sta->max_ampdu_size = 0;
@@ -754,7 +754,7 @@ int wcn36xx_smd_config_bss(struct wcn36xx *wcn, enum nl80211_iftype type,
 	bss->rifs_mode = 0;
 	bss->beacon_interval = beacon_interval;
 	bss->dtim_period = wcn->dtim_period;
-	bss->tx_channel_width_set = 0;
+	bss->tx_channel_width_set = conf_is_ht40(&wcn->hw->conf);
 	bss->oper_channel = wcn->ch;
 	bss->ext_channel = 0;
 	bss->reserved = 0;
@@ -768,7 +768,7 @@ int wcn36xx_smd_config_bss(struct wcn36xx *wcn, enum nl80211_iftype type,
 	sta->listen_interval = 8;
 	sta->wmm_enabled = 0;
 	sta->ht_capable = wcn->supported_rates.supported_mcs_set[0] ? 1 : 0;
-	sta->tx_channel_width_set = 0;
+	sta->tx_channel_width_set = conf_is_ht40(&wcn->hw->conf);
 	sta->rifs_mode = 0;
 	sta->lsig_txop_protection = 0;
 	sta->max_ampdu_size = 0;
-- 
1.7.11.3