Mint does not boot up with boot.img

[Eugene Krasnikov]

Hi Olof,

Here is the log from your boot.img:

[semc_dead_battery_charge] Enter semc_dead_battery_charge
S1 PreBoot "1255-9860 MSM8960_PREBOOT CRH1099189_R10AM002" (2013-01-30 16:39)
QC boot_images delivery: 1532
MID 0: Samsung MMC 'MAG2GA' 14.574 GB
Insane TZBSP header
Primary TZBSP is not valid, falling back to the backup
Invalid sig/cert size for MBN image.
Security is off, making a bold exception and accepts this TZBSP
despite it might be corrupt
Booting on the backup TZBSP
QC trustzone_images delivery: 1532
The cake is a lie!
Chipset info:
Digital baseband: QualComm part number 0x6b5 version data 0x4
Analog baseband: PM8921 rev 3.0 (calculated from rev2=0x600 | rev1=0xf4)
MID 0: Samsung MMC 'MAG2GA' 14.574 GB
S1 Boot "1255-9860 MSM8960_S1BOOT CRH1099189_R10AM002" (2013-01-30 16:38)
TurnOnStatus=[0x02]
ChargerPath=[0x00]
S1 Boot Startup info: [ONKEY PRESSED]
Reboot reason: 0x0 (Coldboot)
TZBSP version: 1.0
ControlledRooting: Status = [Done]
Setup DK: Setup failed with SECMGR error=[1023] ta_status=[4]
Error waiting for write ready
Error waiting for write ready
No Service Mode detected.
boot_partitions: The following partitions will be booted (in this order):
  partID:03
elf_verify: No SIN Header found!
elf_verify: Proceeding since SIN verification is not enforced for partition 3
plf_boot_rpm: RPM image contains an ELF header.
ARM ELF image (0x0028), entry point @ 0x00020000
[plf_rpm:100] RPM entry 0x20000
rpm_elf_verify: Verification success!
plf_boot_rpm: Found ELF start at 0x20000
plf_boot_rpm: Releasing RPM
RPM firmware loaded, version 3.0.16843280
plf_boot_rpm: RPM successfully loaded
Error waiting for write ready
Jumping to kernel at address [0x80208000], all your base are belong to us!


--
Best regards,
Eugene