Comfast CF-E110n

Tue Oct 24 14:32:22 PDT 2023

Hi, Bill,

I have a couple of them, but they're in a remote location I can't access 
right now. However, on one of them, I recently upgraded from OpenWrt 
22.03.X to 23.05.0 and I did not experience such issues.

In order to narrow down the issue, you may want to try flashing this 
older OpenWrt version (which one was it? CF-E110N is supported since 
19.07...), then upgrade one major release at a time (first 21.02, then 
22.03, until 23.05). When does this issue appear, if it does?

Best,

Roger

El 23/10/23 a les 23:54, Bill Moffitt ha escrit:
> I have been using an older version of OpenWRT on my E110Ns; I loaded up
> the latest release to see if it would fix some "LOST BEACON" problems.
>
> Unfortunately, it didn't even boot (went into a bootloop), so I broke
> out the serial cable,
> busted open the radio, and connected it. Here's what I captured:
>
> <code>
> U-Boot 1.1.4-ge619c187-dirty (Apr 12 2017 - 18:52:08)
>
> ap143 - Honey Bee 2.0
>
> DRAM:  64 MB
> Flash: 16 MB
>
> dup 1 speed 100
> Using eth0 device
> ping failed; host 192.168.1.10 is not alive
> Unknown command 'ERROR!' - try 'help'
> Hit any key to stop autoboot:  1     0
> ## Booting image at 9f020000 ...
>     Image Name:   MIPS OpenWrt Linux-5.15.134
>     Created:      2023-10-09  21:45:35 UTC
>     Image Type:   MIPS Linux Kernel Image (lzma compressed)
>     Data Size:    2328775 Bytes =  2.2 MB
>     Load Address: 80060000
>     Entry Point:  80060000
>     Verifying Checksum at 0x9f020040 ...OK
>     Uncompressing Kernel Image ... OK
> No initrd
> ## Transferring control to Linux (at address 80060000) ...
> ## Giving linux memsize in bytes, 67108864
>
> Starting kernel ...
>
> [    0.000000] Linux version 5.15.134 (builder at buildhost)
> (mips-openwrt-linux-musl-gcc (OpenWrt GCC 12.3.0 r23497-6637af95aa)
> 12.3.0, GNU ld (GNU Binutils) 2.40.0) #0 Mon Oct 9 21:45:35 2023
> [    0.000000] printk: bootconsole [early0] enabled
> [    0.000000] CPU0 revision is: 00019374 (MIPS 24Kc)
> [    0.000000] MIPS: machine is COMFAST CF-E110N v2
> [    0.000000] SoC: Qualcomm Atheros QCA9533 ver 2 rev 0
> [    0.000000] Initrd not found or empty - disabling initrd
> [    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
> [    0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases,
> linesize 32 bytes
> [    0.000000] Zone ranges:
> [    0.000000]   Normal   [mem 0x0000000000000000-0x0000000003ffffff]
> [    0.000000] Movable zone start for each node
> [    0.000000] Early memory node ranges
> [    0.000000]   node   0: [mem 0x0000000000000000-0x0000000003ffffff]
> [    0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff]
> [    0.000000] Built 1 zonelists, mobility grouping on.  Total pages: 16240
> [    0.000000] Kernel command line: console=ttyS0,115200n8
> rootfstype=squashfs,jffs2
> [    0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768
> bytes, linear)
> [    0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384
> bytes, linear)
> [    0.000000] Writing ErrCtl register=00000000
> [    0.000000] Readback ErrCtl register=00000000
> [    0.000000] mem auto-init: stack:off, heap alloc:off, heap free:off
> [    0.000000] Memory: 55972K/65536K available (6077K kernel code,
> 591K rwdata, 780K rodata, 1184K init, 217K bss, 9564K reserved, 0K
> cma-reserved)
> [    0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
> [    0.000000] NR_IRQS: 51
> [    0.000000] CPU clock: 650.000 MHz
> [    0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles:
> 0xffffffff, max_idle_ns: 5880801374 ns
> [    0.000002] sched_clock: 32 bits at 325MHz, resolution 3ns, wraps
> every 6607641598ns
> [    0.008370] Calibrating delay loop... 432.53 BogoMIPS (lpj=2162688)
> [    0.074950] pid_max: default: 32768 minimum: 301
> [    0.080919] Mount-cache hash table entries: 1024 (order: 0, 4096
> bytes, linear)
> [    0.088644] Mountpoint-cache hash table entries: 1024 (order: 0,
> 4096 bytes, linear)
> [    0.105660] clocksource: jiffies: mask: 0xffffffff max_cycles:
> 0xffffffff, max_idle_ns: 19112604462750000 ns
> [    0.116125] futex hash table entries: 256 (order: -1, 3072 bytes, linear)
> [    0.123566] pinctrl core: initialized pinctrl subsystem
> [    0.131441] NET: Registered PF_NETLINK/PF_ROUTE protocol family
> [    0.138492] thermal_sys: Registered thermal governor 'step_wise'
> [    0.153766] clocksource: Switched to clocksource MIPS
> [    0.167301] NET: Registered PF_INET protocol family
> [    0.172759] IP idents hash table entries: 2048 (order: 2, 16384
> bytes, linear)
> [    0.181676] tcp_listen_portaddr_hash hash table entries: 512
> (order: 0, 4096 bytes, linear)
> [    0.190630] Table-perturb hash table entries: 65536 (order: 6,
> 262144 bytes, linear)
> [    0.198823] TCP established hash table entries: 1024 (order: 0,
> 4096 bytes, linear)
> [    0.206939] TCP bind hash table entries: 1024 (order: 0, 4096 bytes, linear)
> [    0.214408] TCP: Hash tables configured (established 1024 bind 1024)
> [    0.221345] UDP hash table entries: 256 (order: 0, 4096 bytes, linear)
> [    0.228344] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes, linear)
> [    0.236302] NET: Registered PF_UNIX/PF_LOCAL protocol family
> [    0.242338] PCI: CLS 0 bytes, default 32
> [    0.251473] workingset: timestamp_bits=14 max_order=14 bucket_order=0
> [    0.264981] squashfs: version 4.0 (2009/01/31) Phillip Lougher
> [    0.271158] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME)
> (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
> [    0.283297] Block layer SCSI generic (bsg) driver version 0.4
> loaded (major 251)
> [    0.296681] pinctrl-single 1804002c.pinmux: 576 pins, size 72
> [    0.304425] Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled
> [    0.314714] printk: console [ttyS0] disabled
> [    0.319327] 18020000.uart: ttyS0 at MMIO 0x18020000 (irq = 9,
> base_baud = 1562500) is a 16550A
> [    0.328537] printk: console [ttyS0] enabled
> [    0.328537] printk: console [ttyS0] enabled
> [    0.337608] printk: bootconsole [early0] disabled
> [    0.337608] printk: bootconsole [early0] disabled
> [    0.373725] spi-nor spi0.0: w25q128 (16384 Kbytes)
> [    0.378894] 4 fixed-partitions partitions found on MTD device spi0.0
> [    0.385536] OF: Bad cell count for /ahb/spi at 1f000000/flash at 0/partitions
> [    0.392416] OF: Bad cell count for /ahb/spi at 1f000000/flash at 0/partitions
> [    0.400124] OF: Bad cell count for /ahb/spi at 1f000000/flash at 0/partitions
> [    0.407094] OF: Bad cell count for /ahb/spi at 1f000000/flash at 0/partitions
> [    0.414211] Creating 4 MTD partitions on "spi0.0":
> [    0.419186] 0x000000000000-0x000000010000 : "u-boot"
> [    0.432380] 0x000000010000-0x000000020000 : "art"
> [    0.438974] 0x000000020000-0x000000ff0000 : "firmware"
> [    0.448501] 2 uimage-fw partitions found on MTD device firmware
> [    0.454736] Creating 2 MTD partitions on "firmware":
> [    0.459874] 0x000000000000-0x000000240000 : "kernel"
> [    0.466527] 0x000000240000-0x000000fd0000 : "rootfs"
> [    0.475397] mtd: setting mtd4 (rootfs) as root device
> [    0.480780] 1 squashfs-split partitions found on MTD device rootfs
> [    0.487281] 0x0000005b0000-0x000000fd0000 : "rootfs_data"
> [    0.495748] 0x000000ff0000-0x000001000000 : "nvram"
> [    0.914866] ag71xx 19000000.eth: Could not connect to PHY device.
> Deferring probe.
> </code>
> (reboot)
>
> Is anyone else using the CF-110N?
>
> -Bill
>
> _______________________________________________
> openwrt-devel mailing list
> openwrt-devel at lists.openwrt.org
> https://lists.openwrt.org/mailman/listinfo/openwrt-devel
>