Problem connecting to VPN

[Alex Branham]

Thanks for the reply.

I can ping the server but it isn't routing my normal internet traffic through the VPN.

I assumed that this was related to the DTLS but perhaps not. 

Alex

David Woodhouse <dwmw2 at infradead.org> writes:

> On Tue, 2016-09-27 at 18:33 -0500, Alex Branham wrote:
>> 
>> 
>> I'm attempting to connect to my school's vpn and it's not working
>> quite as I imagined.I run "sudo openconnect vpn.utexas.edu" and
>> enter in my username, password, and two-factor authentication. It
>> then prints out:
>> 
>> Got CONNECT response: HTTP/1.1 200 OK
>> CSTP connected. DPD 0, Keepalive 20
>> Set up DTLS failed; using SSL instead
>> Connected as 172.29.230.252, using SSL
>> 
>> And this gets added to the output of "ip addr":
>> 
>> 4: tun0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1406 qdisc fq_codel state UNKNOWN group default qlen 500
>>  link/none 
>>  inet 172.29.230.252/32 scope global tun0
>>  valid_lft forever preferred_lft forever
>>  inet6 fe80::d2fa:6c92:c9ee:d6d/64 scope link flags 800 
>>  valid_lft forever preferred_lft forever
>> 
>> I'm running Arch linux with openconnect v7.07. Any help is much appreciated!
>
> Can you elaborate on what it is that you didn't expect?
>
> Is it just the lack of DTLS? Is everything actually working apart from
> that?
>
> Or do you not have routes to the VPN? Can you not ping machines on the
> VPN by their IP address?
>
> Or do you not have DNS?
>
> Or did a pixie jump out from under the table at this point and run away
> with your laptop...?


-- 
J. Alexander Branham
PhD Candidate
Department of Government
University of Texas at Austin
www.jabranham.com