[PATCH v4 5/7] arm64: set CONFIG_MMC_BCM2835=y in defconfig
eric at anholt.net
Fri Mar 17 17:07:17 PDT 2017
Gerd Hoffmann <kraxel at redhat.com> writes:
> We need to enable this controller so that we can switch the SD card's
> pinmux over to it by default, which will improve storage performance.
> Read access (dd with 64k blocks on rpi2):
> CONFIG_MMC_SDHCI_IPROC: 11-12 MB/s
> CONFIG_MMC_BCM2835: 19-20 MB/s
> Differences on write access are pretty much in the noise.
> Signed-off-by: Gerd Hoffmann <kraxel at redhat.com>
Now that the driver has been merged, I've merged the platform patches up
to this point.
Unfortunately, sending PRs to arm-soc that merge in branches from other
trees has failed in the past, so I won't be able to merge 6 and 7 for
4.12. That said, it's a whole lot less that the various downstream
kernels will need to pull for the Pi3 than they've been carrying around
until now :)
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 832 bytes
Desc: not available
More information about the linux-rpi-kernel