[PATCH 00/26] ARM: provide common arch init for DT clocks
csd at broadcom.com
Mon Sep 23 11:41:50 PDT 2013
On 13-09-23 10:45 AM, Matt Porter wrote:
> On 09/22/2013 08:14 AM, Sebastian Hesselbarth wrote:
>> On 09/20/2013 09:16 PM, Matt Porter wrote:
>>> On Wed, Sep 18, 2013 at 07:53:33PM +0200, Sebastian Hesselbarth wrote:
>>>> This is a patch set based on an RFC  sent earlier to provide a
>>>> arch/arm init for DT clock providers. Currently, the call to
>>>> to initialize DT clock providers is spread among several mach-dirs.
>>>> Since most
>>>> machs require DT clocks initialized before timers, no initcall can be
>>> Could you pick up the following patch for mach-bcm/ into this series?
>>> From f65d048b3453447bb3e693cb21701c4d0c6375ed Mon Sep 17 00:00:00 2001
>>> From: Matt Porter <matt.porter at linaro.org>
>>> Date: Fri, 20 Sep 2013 13:41:06 -0400
>>> Subject: [PATCH] ARM: bcm: Remove custom .time_init hook
>>> With arch/arm calling of_clk_init(NULL) and clocksource_of_init()
>>> this is no longer needed. The former is useful because we can make
>>> use of dummy fixed clocks for drivers until the bcm281xx common
>>> clock driver is ready.
>>> Signed-off-by: Matt Porter <matt.porter at linaro.org>
>>> Reviewed-by: Markus Mayer <markus.mayer at linaro.org>
>>> Reviewed-by: Christian Daudt <csd at broadcom.com>
>> As a v2 is required due to calling of_clk_init() breaks non-DT builds,
>> I will include this _if_ Christian actually gives his Acked-By.
> Understood. Ccing Christian's new email as it just changed.
Old one still works for this week :)
Acked-by: Christian Daudt <csd at broadcom.com>
More information about the linux-rpi-kernel