[PATCH 00/26] ARM: provide common arch init for DT clocks

Matt Porter matt.porter at linaro.org
Mon Sep 23 10:45:44 PDT 2013


On 09/22/2013 08:14 AM, Sebastian Hesselbarth wrote:
> On 09/20/2013 09:16 PM, Matt Porter wrote:
>> On Wed, Sep 18, 2013 at 07:53:33PM +0200, Sebastian Hesselbarth wrote:
>>> This is a patch set based on an RFC [1][2] sent earlier to provide a
>>> common
>>> arch/arm init for DT clock providers. Currently, the call to
>>> of_clk_init(NULL)
>>> to initialize DT clock providers is spread among several mach-dirs.
>>> Since most
>>> machs require DT clocks initialized before timers, no initcall can be
>>> used.
> [...]
>> Could you pick up the following patch for mach-bcm/ into this series?
>>
>> Thanks,
>> Matt
>>
>>  From f65d048b3453447bb3e693cb21701c4d0c6375ed Mon Sep 17 00:00:00 2001
>> From: Matt Porter <matt.porter at linaro.org>
>> Date: Fri, 20 Sep 2013 13:41:06 -0400
>> Subject: [PATCH] ARM: bcm: Remove custom .time_init hook
>>
>> With arch/arm calling of_clk_init(NULL) and clocksource_of_init()
>> this is no longer needed. The former is useful because we can make
>> use of dummy fixed clocks for drivers until the bcm281xx common
>> clock driver is ready.
>>
>> Signed-off-by: Matt Porter <matt.porter at linaro.org>
>> Reviewed-by: Markus Mayer <markus.mayer at linaro.org>
>> Reviewed-by: Christian Daudt <csd at broadcom.com>
>
> As a v2 is required due to calling of_clk_init() breaks non-DT builds,
> I will include this _if_ Christian actually gives his Acked-By.

Understood. Ccing Christian's new email as it just changed.

Thanks,
Matt




More information about the linux-rpi-kernel mailing list