[PATCH v2 3/3] drm/rockchip: dw_dp: Attach "max bpc" connector property

[Chaoyi Chen]

On 9/10/2026 3:51 PM, Igor Paunovic wrote:
> Hi Chaoyi,
> 
> On 9/10/26 09:16, Chaoyi Chen wrote:
>> I don't think this is the correct way to go.
>>
>> I believe max_bpc should be handled in drm_bridge_connector_init().
>> Take a look at its implementation. HDMI already does max_bpc there,
>> so DP should probably do something similar.
> 
> Agreed - that is the question I left open in my reply to the bot. v3
> moves it into drm_bridge_connector_init() and drops this glue patch.
> 
> Three points I would rather ask than guess, since it is shared code:
> 
> 1. How the bridge advertises it. drm_bridge.max_bpc is documented as
>    "only relevant if DRM_BRIDGE_OP_HDMI is set" and the helper only
>    reads it inside the OP_HDMI block. I intend to honour it on the
>    non-HDMI path too, relax that doc sentence, and have dw-dp set
>    bridge->max_bpc = 10. If you prefer to keep the field HDMI-only,
>    a separate field is easy - I just did not want to add one unasked.
>

Maybe we should consider adding a new "DRM_BRIDGE_OP_DP" :)

> 2. The range. HDMI attaches 8..max_bpc. dw-dp's format table goes down
>    to 6 bpc RGB and i915 attaches 6..N on its DP connectors, so I intend
>    6..max_bpc when connector_type is DisplayPort, 8..max_bpc otherwise -
>    the same gate Dmitry used for the DP subconnector property in his
>    msm series [1]. Nothing is attached unless a bridge declared
>    max_bpc, so existing non-HDMI bridge connectors are unchanged.
> 

And once you use DRM_BRIDGE_OP_DP for the check, it shouldn't affect
other users. The max_bpc looks reasonable.

> 3. Where the default lives. 2/3 restores max_requested_bpc from
>    connector->max_bpc after drm_mode_config_reset(), but Cristian's
>    v11 71/74 removes that field [2] (HDMI keeps it in hdmi.funcs). I
>    intend to keep the value in struct drm_bridge_connector and restore
>    it from there in drm_bridge_connector_create_state(), which folds
>    2/3 into the same patch. 1/3 is unaffected.
> 
> The state still has to exist before the property is attached, so the
> non-HDMI path gets the same create-state block drmm_connector_hdmi_init()
> has. If you would rather see that block factored into a helper for both
> callers, say so and I will do that instead.
> 

Perhaps @Cristian and @Maxime have better ideas?

> [1] https://lore.kernel.org/all/20260722-drm-msm-display-interface-v1-24-368c10fe62fd@oss.qualcomm.com/
> [2] https://lore.kernel.org/all/20260901-dw-hdmi-qp-scramb-v11-71-bc12954a0688@collabora.com/
> 
> Thanks,
> Igor

-- 
Best, 
Chaoyi