[PATCH v2 3/3] drm/rockchip: dw_dp: Attach "max bpc" connector property

[Igor Paunovic]

Hi Chaoyi,

On 9/10/26 09:16, Chaoyi Chen wrote:
> I don't think this is the correct way to go.
>
> I believe max_bpc should be handled in drm_bridge_connector_init().
> Take a look at its implementation. HDMI already does max_bpc there,
> so DP should probably do something similar.

Agreed - that is the question I left open in my reply to the bot. v3
moves it into drm_bridge_connector_init() and drops this glue patch.

Three points I would rather ask than guess, since it is shared code:

1. How the bridge advertises it. drm_bridge.max_bpc is documented as
   "only relevant if DRM_BRIDGE_OP_HDMI is set" and the helper only
   reads it inside the OP_HDMI block. I intend to honour it on the
   non-HDMI path too, relax that doc sentence, and have dw-dp set
   bridge->max_bpc = 10. If you prefer to keep the field HDMI-only,
   a separate field is easy - I just did not want to add one unasked.

2. The range. HDMI attaches 8..max_bpc. dw-dp's format table goes down
   to 6 bpc RGB and i915 attaches 6..N on its DP connectors, so I intend
   6..max_bpc when connector_type is DisplayPort, 8..max_bpc otherwise -
   the same gate Dmitry used for the DP subconnector property in his
   msm series [1]. Nothing is attached unless a bridge declared
   max_bpc, so existing non-HDMI bridge connectors are unchanged.

3. Where the default lives. 2/3 restores max_requested_bpc from
   connector->max_bpc after drm_mode_config_reset(), but Cristian's
   v11 71/74 removes that field [2] (HDMI keeps it in hdmi.funcs). I
   intend to keep the value in struct drm_bridge_connector and restore
   it from there in drm_bridge_connector_create_state(), which folds
   2/3 into the same patch. 1/3 is unaffected.

The state still has to exist before the property is attached, so the
non-HDMI path gets the same create-state block drmm_connector_hdmi_init()
has. If you would rather see that block factored into a helper for both
callers, say so and I will do that instead.

[1] https://lore.kernel.org/all/20260722-drm-msm-display-interface-v1-24-368c10fe62fd@oss.qualcomm.com/
[2] https://lore.kernel.org/all/20260901-dw-hdmi-qp-scramb-v11-71-bc12954a0688@collabora.com/

Thanks,
Igor