[PATCH v3 11/12] dt-bindings: pci: rockchip,rk3399-pcie-ep: Add ep-gpios property

[Damien Le Moal]

On 10/7/24 15:54, Krzysztof Kozlowski wrote:
> On 07/10/2024 08:50, Damien Le Moal wrote:
>> On 10/7/24 15:12, Krzysztof Kozlowski wrote:
>>> On Mon, Oct 07, 2024 at 01:12:17PM +0900, Damien Le Moal wrote:
>>>> From: Wilfred Mallawa <wilfred.mallawa at wdc.com>
>>>>
>>>> Describe the `ep-gpios` property which is used to map the PERST# input
>>>> signal for endpoint mode.
>>>
>>> Why "ep" for PERST signal? Looks totally unrelated name. There is
>>> already reset-gpios exactly for PERST, so you are duplicating it. Why?
>>
>> Because the host side controller already has the same "ep-gpios" property.
>>
>> Documentation/devicetree/bindings/pci/rockchip,rk3399-pcie.yaml
> 
> If host has it, then it is a common property so goes to common schema
> for these devices.

Ah. OK. I will move it to
Documentation/devicetree/bindings/pci/rockchip,rk3399-pcie-common.yaml then.

>> So naming that property the same allows common code to initialize that gpio in
>> rockchip_pcie_parse_dt().
>>
>> Also, I do not see reset-gpios being defined/used by this driver (host and ep
>> sides).
> 
> I am talking about bindings, not driver.

I do not see reset-gpios being defined in the bindings (common, host and ep).
resets and reset-names are defined though but these have nothing to do with
#PERST control.

-- 
Damien Le Moal
Western Digital Research